SECTION
SECTION 10—WHEELS AND CASTERS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that on/off switch on the joystick is in the off position.
DO NOT USE YOUR WHEELCHAIR UNLESS IT HAS THE PROPER TIRE PRESSURE (P.S.I.) - OTHERWISE THE WHEELCHAIR MAY NOT DRIVE CORRECTLY, STOP CORRECTLY OR MAY EXPERIENCE ERRATIC PERFORMANCE.
DO NOT overinflate the tires. Failure to follow these suggestions may cause the tire to explode and cause bodily harm. The recommended tire pressure is listed on the side wall of the tire.
Keep fingers and clothing clear of drive wheels.
CAUTION
As with any vehicle, the wheels, casters and tires should be checked periodically for cracks and wear and should be replaced.
REPLACING FRONT CASTERS
NOTE: For this procedure, refer to FIGURE 10.1.
1.Remove the mounting bolt, two (2) spacers and locknut that secures the caster to the fork.
2.Remove the caster and discard.
3.Secure new caster to fork with the existing mounting bolt, two (2) spacers and locknut. Securely tighten.
4.Repeat STEPS
Wheelchair
Frame
Fork
Mounting Bolt
Locknut
Spacer
Front Caster | Spacer |
FIGURE 10.1 - REPLACING FRONT
CASTERS
At’m | 40 | Part No. 1125035 |