Invacare At'm manual Removing

Page 36

SECTION 8—BATTERIES

REMOVING/INSTALLING THE BATTERIES FROM/ INTO THE BATTERY PACK

NOTE: For this procedure, refer to FIGURE 8.3.

REMOVING

1.Remove the battery pack from the wheelchair. Refer to Removing/Installing the Battery Pack on page 35.

2.Open the battery pack by performing the following -

A.Grasp the side flaps and pull up.

B.Grasp the front flap and pull up.

3.Disconnect the wiring harness from the batteries in the following order -

A.NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal on the left battery.

B.POSITIVE (+) RED battery cable from POSITIVE (+) battery terminal/post on the right battery.

C.WHITE battery cable (jumper) from the POSITIVE (+) battery terminal/post on the left battery and the NEGATIVE (-) battery terminal/post on the right battery.

4.Remove the batteries from the battery pack.

INSTALLING

1.Install the batteries into the battery pack in the orientation shown in FIGURE 8.3.

2.Connect the wiring harness to the batteries in the following order -

A.NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the left battery.

B.POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post on the right battery.

C.WHITE battery cable (jumper) to the POSITIVE (+) battery terminal/post on the left battery and the NEGATIVE (-) battery terminal/post on the right battery.

3.Slide the red and black battery connector out of the battery pack in the slit provided on the front flap.

4.Close the battery pack by performing the following -

A.Fold down the front flap and press to engage the hook and loop straps.

B.Fold down the side flaps and press to engage the hook and loop straps.

NOTE: Ensure that the hook and loop straps are securely fastened before lifting the battery pack.

5.Install the battery pack on the wheelchair. Refer to Removing/Installing the Battery Pack on page 35.

At’m

36

Part No. 1125035

Image 36
Contents At’m At’m Table of Contents Seat Table of Contents Register Your Product Complete and mail the form on the nextProduct Registration Form Fold here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsLabel Location Typical Product Parameters ParametersController SETTINGS/REPAIR or Service General GuidelinesTire Pressure Operation InformationGeneral Guidelines Accessories BatteriesCharging Batteries Weight Training Weight LimitationGrounding Instructions Rain TestEMI Information EMI Information SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping with Everyday Obstacles LIFTING/STAIRWAYS Percentage of Weight Distribution REACHING, Leaning and Bending ForwardReaching and Bending Backward Safety INSPECTION/ Troubleshooting Safety Inspection ChecklistsINSPECT/ADJUST Initially INSPECT/ADJUST Weekly INSPECT/ADJUST MonthlyINSPECT/ADJUST Periodically Troubleshooting Guide Symptom Probable Cause SolutionsTurning the Power ON/OFF Using the Joystick to Drive the ChairWheelchair Operation Operating the WheelchairUsing the Horn Movement ActionJoystick Switches and Indicators ON/OFF ButtonSpeed Control Knob JoystickWheelchair Operation Display Description Definition Comments Resetting the Circuit Breaker Multi Function Charger PortREMOVING/INSTALLING the Seat InstallingSeat RemovingREMOVING/INSTALLING the Seat Replacing Seat Positioning Strap Replacing Seat Positioning StrapDISCONNECTING/CONNECTING the Joystick DisconnectingConnecting JoystickRepositioning the Joystick Repositioning the JoystickRecommended Battery Type BatteriesREMOVING/INSTALLING the Battery Pack REMOVING/INSTALLING the Battery PackRemoving REMOVING/INSTALLING the Batteries FROM/INTO Battery Pack Charging BatteriesMulti-Function Charger Port Motors ENGAGING/DISENGAGING the MotorsWheels and Casters Replacing Front CastersAdjusting Forks Adjusting ForksREMOVING/INSTALLING the Drive Wheels REMOVING/INSTALLING the Drive WheelsTransporting the Wheelchair Limited Warranty USA