Invacare L-3, L-4 user manual Product Labeling, Serial Number Label

Page 17
1118373 Rev A

3 PRODUCT LABELING

3 Product Labeling

Lynx L-3 shown. The labels are in the same locations for the Lynx L-4.

! WARNING

Pinch Point.

1079203

Serial

Number

Label

DO NOT operate the scooter unless the tiller is in the locked position.

DO NOT lean against or pull forward on the tiller while mounting or dismounting the scooter. Otherwise, injury may occur.

--------------------------------------------------------------------------------------------

DO NOT lift scooter up by the front or rear shroud. Otherwise injury or damage to the scooter may occur.

Part No. 1143205

17

Invacare® Lynx™ L-3& Invacare® Lynx™ L-4 Scooters

Image 17
Contents Invacare Lynx L-3 Invacare Lynx L-4 Contents Wheels and Casters General SymbolsLimited Warranty General Guidelines SafetyDo not operate on roads, streets or highways Operation Information SetupTransport Stairways and Escalators Safety/Handling of Powered Scooters Repair or Service InformationSafety Safety Rain Test StorageElectrical and Grounding BatteryWeight Training Weight limitation is 300 lbs Weight LimitationDisposal EMI InformationPowered Wheelchair Electromagnetic Interference EMI Safety Serial Number Label Product LabelingBattery wiring label is on the underside Battery box door Typical Product Parameters Overall Dimensions Technical DataSeat Dimensions Arm DimensionsDriving WeightWheels Inspection Safety Inspection ChecklistsInspect/Adjust Weekly Inspect/Adjust InitiallyInspect/Adjust Periodically Inspect/Adjust MonthlyControl Panel Operating the Powered Scooter For this procedure, refer to .1 on Control Panel Operating the ScooterOperating the Powered Scooter Engaging/Disengaging the Brake Release Lever Pull Back to Engage Drive Push Forward to DisengageInstalling Removing/Installing the SeatSeat and Arms RemovingAdjusting Seat Height Adjusting Seat HeightAdjusting 90 Seat Swivel Adjusting 90 Seat SwivelReplacing Armrest Pads Adjusting the Arm WidthAdjusting the Tiller Angle Tiller AdjustmentTiller locks into one of three positions. StorageWheels and Casters Removing/Installing the Drive WheelsPlace keystock* in cutout on drive shaft as shown in Figure Removing/Installing the Front WheelBatteries Recommended Battery Type Recommended Battery TypeRemoving/Installing the Battery Box  For this procedure, refer to .3 on Removing/Installing the BatteriesInstalling Removing/Installing the Batteries Charging the Batteries  The battery charger light will be Yellow or RED Disassembling TransportingTransporting the Scooter Assembling Seat Post AssemblyRelease LeverInstalling/Removing the Accessory Tube AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Crutch/Cane HolderInstalling/Removing the Safety Flag Installing/Removing the Safety FlagInstalling/Removing the Walker Holder Installing/Removing/Using the Walker Holder Reverse this procedure to remove the walker holder Using the Walker HolderInstalling/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketSuggested Maintenance Procedures MaintenanceGeneral Troubleshooting TroubleshootingSlowly decelerating to a stop  For the following table, refer to .1 on Service Indicator Error CodesSeat Circuit Breaker Button Resetting the Circuit BreakerUSA
Related manuals
Manual 6 pages 63.87 Kb