Invacare L-4, L-3 user manual Wheels and Casters, Removing/Installing the Drive Wheels

9 WHEELS AND CASTERS

9 Wheels and Casters

WARNING

￿ After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, turn power Off and remove key from ignition.

9.1 Removing/Installing the Drive Wheels

For this procedure, refer to FIGURE 9.1 on page 34.

This procedure applies to the rear wheels on the Lynx L-3 and all wheels on the Lynx L-4.

Removing

1.Turn power off and remove the key from the ignition.

2.Remove the seat. Refer to Removing/Installing the Seat on page 23.

3.Place the rear frame assembly (not shown) up on blocks so that the drive wheels are off the ground.

4.Remove the washer and mounting screw that secure the drive wheel to the drive shaft.

5.Remove the existing drive wheel assembly from the drive shaft.

Use a wheel puller if necessary to remove the wheel from the drive shaft.

6.Remove keystock from drive shaft. Set aside.

7.If necessary, repeat STEPS 1-7 to remove other drive wheel.

*The keystock is not present on the front wheels of the Lynx L-4 scooters.

Keystock*	Drive Wheel
	Washer
Drive Shaft	Mounting Screw
FIGURE 9.1 Removing/Installing the Drive Wheels

Invacare® Lynx™ L-3& Invacare® Lynx™ L-4 Scooters 34 Part No. 1143205