Invacare L-3, L-4 Removing/Installing the Batteries,  For this procedure, refer to .3 on

Page 39

10 BATTERIES

DETAIL “A”

DETAIL “B”

 

Battery Tray

Release Lever

Battery Box

Handle

Battery Box

Connector on Base

FIGURE 10.2 Removing/Installing the Battery Box

10.3Removing/Installing the Batteries

For this procedure, refer to FIGURE 10.3 on page 41.

Removing

1.Remove the seat. Refer to Removing/Installing the Seat on page 23.

2.Remove the battery box from the scooter. Refer to Removing/Installing the Battery Box on page 38.

3.Remove the twelve mounting screws (not shown) that secure the battery box top to the battery box (Detail “A” of FIGURE 10.3).

Mounting screws are located on the underside of the battery box.

Part No. 1143205

39

Invacare® Lynx™ L-3& Invacare® Lynx™ L-4 Scooters

Image 39
Contents Invacare Lynx L-3 Invacare Lynx L-4 Contents Wheels and Casters General SymbolsLimited Warranty General Guidelines SafetyOperation Information Setup TransportDo not operate on roads, streets or highways Stairways and Escalators Safety/Handling of Powered Scooters Repair or Service InformationSafety Safety Rain Test StorageBattery Weight TrainingElectrical and Grounding EMI Information Weight LimitationWeight limitation is 300 lbs DisposalPowered Wheelchair Electromagnetic Interference EMI Safety Serial Number Label Product LabelingBattery wiring label is on the underside Battery box door Arm Dimensions Technical DataTypical Product Parameters Overall Dimensions Seat DimensionsWeight WheelsDriving Inspection Safety Inspection ChecklistsInspect/Adjust Weekly Inspect/Adjust InitiallyInspect/Adjust Periodically Inspect/Adjust MonthlyOperating the Powered Scooter  For this procedure, refer to .1 onControl Panel Control Panel Operating the ScooterOperating the Powered Scooter Engaging/Disengaging the Brake Release Lever Pull Back to Engage Drive Push Forward to DisengageRemoving Removing/Installing the SeatInstalling Seat and ArmsAdjusting Seat Height Adjusting Seat HeightAdjusting 90 Seat Swivel Adjusting 90 Seat SwivelReplacing Armrest Pads Adjusting the Arm WidthStorage Tiller AdjustmentAdjusting the Tiller Angle Tiller locks into one of three positions.Wheels and Casters Removing/Installing the Drive WheelsPlace keystock* in cutout on drive shaft as shown in Figure Removing/Installing the Front WheelBatteries Recommended Battery Type Recommended Battery TypeRemoving/Installing the Battery Box  For this procedure, refer to .3 on Removing/Installing the BatteriesInstalling Removing/Installing the Batteries Charging the Batteries  The battery charger light will be Yellow or RED Transporting Transporting the ScooterDisassembling Lever Seat Post AssemblyAssembling ReleaseInstalling/Removing the Accessory Tube AccessoriesInstalling/Removing the Crutch/Cane Holder Installing/Removing the Crutch/Cane HolderInstalling/Removing the Safety Flag Installing/Removing the Safety FlagUsing the Walker Holder Installing/Removing/Using the Walker HolderInstalling/Removing the Walker Holder  Reverse this procedure to remove the walker holderInstalling/Removing the Rear Mounted Basket Installing/Removing the Rear Mounted BasketSuggested Maintenance Procedures MaintenanceGeneral Troubleshooting TroubleshootingSlowly decelerating to a stop  For the following table, refer to .1 on Service Indicator Error CodesSeat Circuit Breaker Button Resetting the Circuit BreakerUSA
Related manuals
Manual 6 pages 63.87 Kb