Omega Engineering #M3350/0101 Stopping Recipe Execution, To stop execution of a CN8-SW recipe

CN8-SW™UserÕs Guide

9.3.4 Stopping Recipe Execution

To stop execution of a CN8-SW recipe:

1.While logged in as MULTI (or another user with View/Change Parameter privileges), select Ramp/Soak Stop. The Recipe Control window will open.

2.The window lists all the recipes being run under the direction of CN8-SW (both active and held). A recipe may appear on the list in the left pane more than once. This means that you started to run the recipe on different controllers (or sets of controllers) at different times. Each of these occurrences of a recipe on the list is referred to as an ÒinstanceÓ of the recipe.

To see on which controller(s) you are currently running an instance of a recipe, click on the name of the recipe.

3.Select the instance of the recipe to be stopped.

4.Select one or more controllers. (You can hold down the Shift key to select multiple controllers that are together on the list, or hold down the Control key to select multiple controllers that are scattered on the list.)

5.Click on Stop. Running of the selected instance of the CN8-SW recipe using the selected controllers will end. The setpoint for each selected controller will remain where the setpoint was when the recipe was stopped, not at the value determined by the Termination State configured for the recipe.

9-8