SECTION
SECTION 2—COMPONENT
REPLACEMENT
CAUTION
Ensure not to damage ribbon cable when removing or installing front cover. DO NOT use Methyl Ethyl Ketone (MEK). This will damage the plastic.
Replacing the Gross Particle Filter or Filter Cover
NOTE: For this procedure, refer to
FIGURE 2.1.
NOTE: The gross particle filter should be replaced as needed.
1.Lift filter cover slightly and pull down to remove tabs from the grooves.
2.Lift out the filter from the filter cover.
3.Use a vacuum cleaner or wash with a mild liquid dish detergent (such as Dawn™) and water. Rinse thoroughly.
4.Thoroughly dry the filter and inspect for fraying, crumbling, tears and holes.
5.Replace filter cover and/or filter.
6.Reinstall the filter cover by placing the tabs in the slots and engaging the magnet.
NOTE: Use only Invacare gross particle filter.
L
MagnetCover
|
| Tabs | Filter |
|
|
| |
Grooves | Cover |
| Cover |
Magnet
Filter
FIGURE 2.1 Replacing the Gross Particle
Filter or Filter Cover
Accessing XPO2
WARNING
When accessing the XPO2 remember that battery power is still being applied to the internal (PCB) printed circuit board. Care MUST be taken to minimize contact with the PCB. DO NOT use any kind of tool (screwdriver, pliers, etc.) when working on the internal structure, otherwise, injury and/or damage may occur. Battery power remains on the PCB as long as the battery connection is made to the PCB.
NOTE: For this procedure, refer to FIGURE 2.2 and FIGURE 2.3 on page 10.
Part No 1150748 | 9 | XPO2™ |