Invacare HF2E540M9 manual Disconnecting the Cylinder from the Compressor

Page 17

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE

11.After the cylinder is full, press the compressor power switch to the Off (O) position (FIGURE 4.5).

12.Grasp the cylinder assembly (FIGURE 4.5).

13.With the other hand, grasp the outer ring (sleeve) of the connector fillport and push DOWN (FIGURE 4.5).

14.Lift up on the cylinder assembly to remove from the connector fillport (FIGURE 4.5).

PUSH DOWN

Outer Ring

(Sleeve)

Cylinder

Cylinder

Assembly

Fillport

 

Power

 

Switch

Compressor

Connector

Fillport

 

FIGURE 4.5 Disconnecting the Cylinder from the Compressor

15.When the cylinder fillport is disconnected from the connector fillport, release the outer ring (sleeve) of the connector fillport (FIGURE 4.5).

16.Remove the cylinder from the compressor cradle (FIGURE 4.5).

Part No 1163156

17

HomeFill® Cylinder

Image 17
Contents HomeFill Cylinder Oxygen 540 Valve HomeFill Cylinder Table of Contents Intended USE Special NotesReceiving Inspection General Guidelines General Guidelines General Guidelines Product Diagram FeaturesTypical Product Parameters Cylinder Prefill Inspection Inspection and Compressor InterfaceExternal Examination Checking Cylinder Pressure Filling the Cylinder Fillport Covers Resetting Connector Fillport Connecting the Cylinder to the Compressor Disconnecting the Cylinder from the Compressor Connector Fillport Maintenance Cylinder Fill Times TroubleshootingHomeFill Cylinder Limited Warranty Limited Warranty USA