MaxTech OM-25ME operating instructions Problem Solving

Page 22

5. PROBLEM SOLVING

If the "LOW BAT" icon is displayed on the LCD readout at any time, the batteries should be replaced as quickly as possible.

When the unit is in the power on mode and the LCD displays "000%," the sensor is not connected properly. The "ATTACH SENSOR" icon will also appear on the display. Check the sensor connection and if the condition persists, contact Maxtec's Customer Service Department.

If, at any time, "ErX" (i.e. Er1, Er4, etc.) appears on the LCD readout, contact Maxtec's Customer Service Department.

6. CLEANING AND MAINTENANCE

• When cleaning or disinfecting the MAXO2 Monitor, take appropriate care to prevent any solution from entering the instrument.

The MAXO2 Monitors surface may be cleaned using a mild detergent and a moist cloth.

The MAXO2 Monitor may be disinfected using standard topical disinfectants.

The MAXO2 Monitor is not intended for steam, ethylene oxide or radiation sterilization.

Store the MAXO2 Monitor in a temperature similar to its ambient environment of daily use.

15

Image 22
Contents Model OM-25ME Page Page Preface Iii Page SET-UP Procedure Base Unit Specifications Sensor SpecificationsBase Unit Description Components Description please refer to LCD ReadoutLCD Readout Alarm LEDs Keypad External ProbeAlarm LEDs External Probe MAX-250E Oxygen Sensor Battery Installation Calibrating the MAXO2 Monitor Before You BeginTo Calibrate the MAXO2 Monitor Automatic Calibration to Room Air Effects of Temperature Pressure Effect Humidity EffectAlarm Setting Procedure Low Alarm Setting Basic Operation Sensor Removal and Replacement Problem Solving Base Unit Specifications Exposure to Anesthetic Gases Calibration Techniques in Pressurized SystemsCalibration Errors Page Spare Parts and Accessories Warranty Page Email sales@maxtecinc.com