PROGRAM CHANGE PARAMETERS
The following list of parameters can be accessed if the pad event type is set to Program Change.
MIDI CHANNEL FIELD
Program Change messages can be sent on one of two MIDI Ports, A or B, and one of 16 MIDI Channels on each port (i.e. A7). You may also assign Program Change to use the MIDI Common Channel.
1.Use the [<] button to select MIDI Port/Channel field.
2.While in MIDI Port/Channel field, use [VALUE] dial to select desired MIDI Port and Channel.
3.Use the [>] button to select the next field.
MIDI PORT/CHANNEL FIELD
PROGRAM CHANGE FIELD
In this field you can set which Program Change Number the pad will transmit when it is pressed.
1.Use [<] or [>] buttons to select Program Change field.
2.While in Program Change field, use [VALUE] dial to select desired Program Change Number.
3.Use the [>] button to select the next field.
PROGRAM CHANGE FIELD
BANK M FIELD
Bank M describes the Most Significant Byte (MSB) of information.
1. Use [<] or [>] buttons to select Bank M field.
2. While in Bank M field, use [VALUE] dial to select desired value.
3. Use the [>] button to select the next field.
BANK M FIELD
BANK L FIELD
Bank L describes the Least Significant Byte (LSB) of information.
1. | Use the [<] or [>] buttons to select Bank L field. | |||
2. | While in Bank L field, use [VALUE] dial to select desired value. | |||
|
|
|
|
|
|
| Note: | ||
|
|
|
|
|
BANK L FIELD |
| You can also configure pads to send Program Change messages | ||
|
| only, without specifying Bank M and Bank L. While editing Bank M | ||
|
| and Bank L fields of a pad, use [VALUE] dial to set Bank M and Bank | ||
|
| L to ‘OFF’ (beyond 000). This will cause the pad to transmit only a | ||
|
| Program Change message. | ||
|
|
|
|
|
When finished editing, press [ENTER] to save or [<] to cancel the changes.
11