Akai MPD26 manual Gate, Swing

Page 19

NOTE REPEAT BUTTON MODE

The following screen will appear if you select “TOGGL-MOTRY” on Page 1. In this field, you can select whether the [NOTE REPEAT] button will behave in a momentary (MTY) fashion, where pressing the button turns on the Note Repeat function and releasing it turns it off, or in a toggle (TGL) manner, where pressing the button turns on the Note Repeat function and pressing again turns it off.

1.While in Button Mode field, use [VALUE] dial to select Button Mode (Toggle or Momentary).

2.Press [ENTER] to accept change.

BUTTON MODE

NOTE REPEAT PARAMETERS – GATE, SWING

The following parameters can be adjusted if you select “GATE SWING” on Page 1.

GATE

Select the Note Repeat Gate in this field.

1.While in Gate field, use [VALUE] dial to select Gate duration.

2.Use the [>] button to select the next field.

GATE FIELD

SWING

Select the Note Repeat Swing in this field.

1.Use the [>] button to select the Swingfield

2.While in Swing field, use [VALUE] dial to select the desired Swing value.

3.Press [ENTER] to accept changes.

SWING FIELD

17

Image 19
Contents Operators Manual Page Connection Diagram KEY FeaturesTOP Panel Overview 16 18Rear Panel Overview Control Change Displaying InformationControl Aftertouch Previewing Midi Machine Control MMCAbout Modes Preset ModeWhat is a Preset? Preset ModeNavigating Edit Mode Edit ModeEdit Mode Parameters Editing Pads What is a Note Message? What is a Program Change?Midi Channel Field Play Mode FieldPressure Field Bank M Field Program Change FieldBank L Field What is Aftertouch? What is Control Change?Editing Knobs & Faders Minimum Range Field Control Change FieldMaximum Range Field Aftertouch Parameters INCREMENT/DECREMENT Parameters knobs only Please note Editing Note RepeatSwing GateEditing Time Division Default Time DivisionEditing TAP Tempo Editing Transport ControlNavigating Global Mode Global ModeKill Midi Page1 PAD Velocity Curve SysEx transfers to the MPD26 TAP Tempo AverageNavigating Program Change Mode Program Change ModeResetting Factory Defaults Frequently Asked Questions Problem Cause Solution TroubleshootingINPUTS/OUTPUTS Technical SpecificationsContact Information GeneralRev. a