Navigating Program Change Mode

PROGRAM CHANGE MODE

A Program Change, often referred to as a Patch Change, is a MIDI message used for sending data to devices to cause them to change to a new program.

There are two different types of Program Change messages on the MPD26:

PROG CHANGE – This event will transmit a regular Program Change message (0-

127)to your DAW or an external device, allowing you to switch between 128 different program banks.

1.Press the [PROGRAM CHANGE] button.

2.On Page 1, use the [VALUE] dial to select a Prog Change or Prog+Bank message on and press [ENTER].

3.On Page 2, use the [<] and [>] buttons to move through the different options and use the {VALUE] dial to change them.

4.Press [ENTER] to send the message.

PROG+BANK – This event transmits a Program Change message (0-127), along with a Bank L (Least Significant Byte) Change message (0-127) and a Bank M (Most Significant Byte) Change message (0-126), which allows access of up to 16384 different program banks. You can use PROG+BANK if your DAW or external device supports LSB and MSB.

PROG CHANGE (Program Change)

PROG CHANGE allows you to transmit a regular Program Change message.

1.Select PROG CHANGE with the [VALUE] dial.

2.Press [ENTER] to see the next page of parameters.

3.Press the [<] button to access the MIDI CH field – this is the MIDI Channel which will be used to transmit the Program Change message. You can change the MIDI Channel by turning the [VALUE] dial. Then, press [>] to go to the next field.

4.In the PROG field, choose the program number with the [VALUE] dial.

5.Press [ENTER] to send the Program Change message.

PROG+BANK (Program Change with Bank Change)

PROG+BANK allows you to send a Program Change with Bank

Change message to your DAW or external sound module.

1.Select PROG+BANK with the [VALUE] dial.

2.Press [ENTER] to see the next page of parameters.

3.Press the [<] button to access the MIDI CH field – this is the MIDI Channel which will be used to transmit the message. You can change the MIDI Channel by turning the [VALUE] dial. Then, press [>] to go to the next field.

4.In the PROG field, choose the program number with the [VALUE] dial. Press [>] to go to the next field.

5.In the BANK M field, select the MSB (Most Significant Byte) of information. Press [>] to go to the next field.

6.In the BANK L field, select the LSB (Least Significant Byte) of information.

7.Press [ENTER] to send the Bank and Program event.