Wyse Technology wyse vx0le conversion to thinos manual Verify Dhcp is Running

Step 2: Verify DHCP is Running

You can verify DHCP is running by going to Start > Control Panel > Network Connections, double-click your LAN connection (for example, Local Area Connection) to open the Local Area Connection Status dialog box, click the Support tab and then ensure that your Address Type is Assigned by DHCP. If this is not the case, you must correct the problem before continuing. If DHCP is not running do not install Wyse Simple Imager until it is running.

Figure 11 Local Area Connection Status dialog box

Step 3: Install Wyse Simple Imager

Navigate to the Wyse Simple Imager Release 2.0.2 folder on your hard drive (this is the location you selected in "Pre-Installation Checklist"), double-click the WSISetup.exe file to open the installation wizard, and then follow the prompts. It is recommended that you use the default settings provided during installation.

Caution

Be sure that the installation path is the same as the default path of the IIS

FTP root path (for example, C:\Inetpub\ftproot).

Figure 12 Default installation path

After Wyse Simple Imager installation is complete, a Wyse Simple Imager icon will be created on the desktop from which the application can be run.