Panasonic EW3153W manual When Using the Main Unit with Batteries, Turn the main unit over

Ad

Page 13

When Using the Main Unit with Batteries

*Always use alkaline batteries. (4 AA-size Panasonic LR6 alkaline batteries)

•When replacing batteries, always use 4 fresh alkaline batteries of the same type from the same manufacturer, and replace them simultaneously.

1.Turn the main unit over and

remove the battery cover by sliding it in the direction of the arrow while pressing

lightly on the mark.

2. Check the polarities of the batteries and install them correctly.

3. Replace the battery cover and slide it closed.

Notes for using the main unit with batteries

Approximately 150 measurements can be taken. Depending on the conditions, battery life may be dramatically shortened.

Use of the main unit with the dedicated AC adapter (EW31555) (included) is recommended.

Replace batteries when:

• The mark shown to the left appears during use.

• No display appears even if the On/Off and Start button is pressed.

CAUTION:

•Always follow the cautions printed on the batteries.

•Check the polarities of the batteries and install them correctly.

•Remove exhausted batteries promptly.

•If the product will not be used for long periods of time, remove the batteries first.

•Batteries should be used before their expiration date.

Use after the expiration date may result in injury or staining of the surrounding area due to generation of heat, bursting, or leakage.

English 12

Image 13

Contents Instructions English Table of Contents Basics of Blood Pressure IntroductionImportant Instructions Before Use English Precautions to Ensure Safe, Reliable Operation English Systolic Blood Pressure SBP Blood Pressure CategoriesPreparations Prior to Taking Measurements IR transmitter on both sides Connector Arm support Battery cover for main unitParts Identification Main unit View from TopAM/PM comparison button Wireless display View from BottomTurn the main unit over When Using the Main Unit with BatteriesInserting the Batteries into the Wireless Display Adjust the month Setting the time and dateAdjust the date Adjust the hourTaking a Reading AdvicePut the main unit on a table in front of you Sit quietly and relax while taking measurements Posture to obtain accurate measurementsDo not take measurements Arm is applied Positions of the main unit and the wireless displayPress the On/Off and Start button on the main unit MeasurementRemove your arm from the main unit Movement detection function Irregular pulse function When an Error Occurs During Measurement Alarm function signals high blood pressureIf the pressure cuff comes off Press the Memory/Recall button Memory storage is completed Storing blood pressure readingsPress the Memory/Recall button Calling up readings from memoryDeleting all data stored in memory Press the button Press the Adjust button 2 to switch off the unitAfter Use Specifications Mark does not light when an arm is moved Mark was displayed, I retried the measurement When should I measure my blood pressure?Is still higher than usual Care and Maintenance Display Status before error Cause and solution TroubleshootingSymptom Possible cause Press the ring portion on the outside One Panasonic Way 1H-1 Secaucus, NJ No.1 EN, SP