Panasonic EW3153W Setting the time and date, Adjust the month, Adjust the date, Adjust the hour

Page 15

Setting the time and date

*Please be sure to set the date and time before taking the first measurement after purchasing the blood pressure monitor, or after replacing the batteries.

(If you attempt to take measurements without first setting the time and date then “–” will be displayed.)

1. Press the Set button “1” on the wireless display for at least 3 seconds.

2. Adjust the month.

Press the Adjust button “2” to adjust the number of the month.

3. Adjust the date.

(1) Press the Set button “1” and the number for the date will flash.

(2) Press the Adjust button “2” to adjust the number of the date.

4. Adjust the hour.

(1) Press the Set button “1” and the time will flash on and off.

(2) Press the Adjust button “2” to adjust the number of the hour.

5.Adjust the minutes.

(1)Press the Set button “1” and the number for minutes will flash.

(2)Press the Adjust button “2” to adjust the number of minutes.

6.Finally, synchronizing with a time signal, press the Set button “1” to complete the procedure.

• The date and time are alternately displayed in approximately 2 seconds.

7.Press the Adjust button “2” to turn off the unit.

During leap years, 3/1 will be displayed when it is February 29th. Please manually reset the date to 2/29.

English 14

Image 15
Contents Instructions English Table of Contents Basics of Blood Pressure IntroductionImportant Instructions Before Use English Precautions to Ensure Safe, Reliable Operation English Systolic Blood Pressure SBP Blood Pressure CategoriesPreparations Prior to Taking Measurements Main unit View from Top Battery cover for main unitIR transmitter on both sides Connector Arm support Parts IdentificationAM/PM comparison button Wireless display View from BottomTurn the main unit over When Using the Main Unit with BatteriesInserting the Batteries into the Wireless Display Adjust the hour Setting the time and dateAdjust the month Adjust the dateAdvice Taking a ReadingPut the main unit on a table in front of you Sit quietly and relax while taking measurements Posture to obtain accurate measurementsDo not take measurements Arm is applied Positions of the main unit and the wireless displayMeasurement Press the On/Off and Start button on the main unitRemove your arm from the main unit Movement detection function Irregular pulse function When an Error Occurs During Measurement Alarm function signals high blood pressureIf the pressure cuff comes off Press the Memory/Recall button Memory storage is completed Storing blood pressure readingsPress the Memory/Recall button Calling up readings from memoryDeleting all data stored in memory Press the button Press the Adjust button 2 to switch off the unitAfter Use Specifications Mark does not light when an arm is moved When should I measure my blood pressure? Mark was displayed, I retried the measurementIs still higher than usual Care and Maintenance Troubleshooting Display Status before error Cause and solutionSymptom Possible cause Press the ring portion on the outside One Panasonic Way 1H-1 Secaucus, NJ No.1 EN, SP