Ultimate Guide to ASKO Hair Dryer Features and Energy Saving Tips

ASKO DRYER FEATURES

Your new energy-efficient ASKO dryer is designed to give you maximum drying performance using less energy. To make the most of the dryer’s functions and features, we recommend that you read this manual carefully before using your machine for the first time. For operating instructions, refer to the section in this guide for your specific model.

Below is an illustration of the parts and features of your ASKO dryer.

		Power
		Button
	Type Plate	Control
	Type Plate	Panel
	(Type and Serial Number)	Panel
	(Type and Serial Number)
	Lint Filter

Lint Filter	Cleanable Fan
Holder		Condenser Unit
	(behind panel)
		(behind panel)

DRYING SYSTEM

Sensidry™

Model T741, have our state-of-the-art Sensidry system. The machine is equipped with a humidity sensor that ensures different fabrics always dry thoroughly. This sensor turns off the heat when the laundry has reached the appropriate dryness.

ENERGY SAVING TIPS

♦Dry consecutive loads to avoid reheating the dryer.

♦Do not overload the dryer.

♦Use the highest spin speeds allowed for the garments.

♦Do not put extremely wet clothes into the dryer.

OVERHEAT PROTECTION

ASKO dryers are designed with an overheat protection switch that will automatically turn the machine off if the temperature gets too high. The machine will not start until it has cooled down sufficiently.

If the unit shuts down because of overheating, check that the lint filter, vent duct, and the condenser unit are free of lint. These components need to be cleaned on a regular basis. Additionally, the lint filter may need to be cleaned with warm, soapy water and a soft brush a few times a year to ensure the filter screen is not blocked. Using dryer sheets (not recommended) can also cause this problem.

Should the machine turn itself off because of overheating, it will not be possible to restart the unit until it has cooled down sufficiently. This could possibly take up to thirty minutes.

To restart the unit once it has cooled down, press the “Start” button.

NOTE: If your dryer overheats frequently, it may not be vented properly or the room in which it is located may not have sufficient air circulation. Contact your installer to have these issues checked out.

COOL-DOWN

Every program on an ASKO dryer ends with a cool-down cycle to reduce wrinkling. See page 13.

♦Dry like fabrics together (i.e., heavy fabrics together, light fabrics together).

♦Clean the lint filter after each load.

♦Do not over-dry clothes when using the timed program.

♦Spin the clothes at no less than 800 rpm.

Page 3