FREESTANDING INSTALLATION
The dryer can be placed next to the washing machine.
It is essential that the machine is leveled and the locknuts are tight to eliminate vibration noise.
There should be at least 1/2” (12 mm) of space between the washer and dryer.
BUILT-IN INSTALLATION
ASKO dryers can be installed beneath a cabinet or worktop with a minimum height of 34” (864 mm). There must be a gap of about 1/2” (12 mm) all around the machine, including between the rear edge of the machine top panel and the back wall. The opening width must be at least
CONDENSING DRYERS
The condensing models work best when they have good air circulation. Therefore, we don’t recommend they be installed beneath a cabinet. If it is necessary, however, be sure to leave a gap of at least 1/2” (12 mm) on all sides.
Install the dryer so the condensed water will continuously flow into a drain or sink, you will need a drain outlet behind the unit. The maximum drain height is 40” (1016 mm). (See page 4.)
NOTES: The height adjustment for the dryer is
ELECTRICAL CONNECTIONS
WARNING!
This appliance must be properly grounded. Refer to the “Important Safety Instructions” on page 2 for grounding instructions.
The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device.
Connection to a permanently wired supply point must be made only by a qualified electrician.
As supplied:
WARNING:
The receptacle on the rear of the machine is designed to accommodate ASKO washers ONLY (rated
ASKO washers rated
Remove cover to access terminal box. (Requires a
NOTE: In Canada, the dryer is delivered
Page 5