CONNECTING A 3-WIRE POWER CORD
WARNING!
Before starting this procedure, be sure the power is turned off at the breaker/fuse box.
Power Supply Cord
You will need a
10copper wires and a matching
Ground
Ground
Middle
To connect a
NOTE: The numbers in the illustration below corre- late to the step numbers.
1.Turn the power off at the breaker/fuse box.
2.Remove terminal block cover.
3.Use the strain relief attached below the terminal block opening.
4. | Loosen or remove | 4 | |
| center | terminal |
|
| block screw. |
| |
5. | Connect | ground |
|
| (middle ) | wire of |
|
| power supply cord | 5 | |
| to the center, silver- | ||
|
| ||
| colored | terminal | 6 |
| screw. | Tighten |
|
| screw. |
| 7 |
|
|
| |
6.Connect the other wires to outer screws.
7.Tighten the strain relief screws.
8.Replace terminal box cover on back of dryer.
9.Plug dryer into wall receptacle.
10.Turn power on at breaker/fuse box.
CONNECTING A 4-WIRE POWER CORD
WARNING!
Before starting this procedure, be sure the power is turned off at the breaker/fuse box.
Power Supply Cord
You will need a
10copper wires and a matching
Page 6
To connect a
NOTE: The numbers in the illustration below corre- late to the step numbers.
1.Turn the power off at the breaker/fuse box.
2.Remove terminal block cover.
3.Use the strain relief attached below the terminal block opening.
4.Remove center
terminal block screw. 54
5. | Remove ground wire | 6 |
| |
| (green with yellow |
|
| |
| stripes) from external |
|
| |
| ground | connector |
|
|
| screw. Fasten under |
|
| |
| center, | 7 |
| |
| terminal block screw. |
| ||
|
|
| ||
6. | Connect | ground | 8 | 9 |
| (green) wire of cord to | |||
|
|
| ||
| external | ground |
|
|
| conductor screw. |
|
| |
7.Connect neutral (white) wire of cord under center screw of terminal block.
8.Connect the other wires to outer screws.
9.Tighten the strain relief screws.
10.Replace terminal box cover on back of dryer.
11.Plug dryer into wall receptacle.
12.Turn power on at breaker/fuse box.