REVERSING THE DOOR HINGES
The door hinges on ASKO dryers are reversible. The dryers are shipped
WARNING! Switch off the main power supply before you start this procedure.
1.Remove the two 20 torx screws on the bottom of the bottom panel then grasp the bottom of the panel and pull it forward and down.
11.Tighten the screws on the sides of the doors to hold the magnetic catch and cover plate in place.
12. Using a flathead screwdriver, carefully remove the plastic plugs in the upper and lower edge of the door and place them in the empty holes on the opposite side.
2. Remove the bottom hinge |
|
bracket by removing the three | 1 |
screws holding the bracket in place.
3.Supporting the door from the bottom, pull it out and to the left as you turn the hinge bracket counter- clockwise.
4.Remove the hinge pin at the top of the hing bracket.
5.Turn the hinge bracket upside down and put the hinge pin into the top hole.
2 3
Hinge
pin
13. Remove the screw in the top right corner of the bottom panel. (If you have a condenser dryer, you will have to open the condenser unit door.)
14.Now you are ready to mount the door on the right side. Holding the door at an angle (as illustrated), fit the hinge pin into the top hole.
6.Transfer the top hinge pin to the right side of the dryer casing.
7.Loosen the two screws on both outer edges of the door so you can remove the magnetic door catch and the cover plate.
8.Remove the magnetic catch by pushing it up then lifting it
out from the bottom.
9.Remove the cover plate on the opposite side of the door by pushing it down then lifting it out from the top.
10.Reverse steps 8 and 9 to place the door catch and cover plate into their new positions.
15. Position the bottom hinge bracket | a |
and secure it with the screws in the | d |
| |
order illustrated at right (a, b, c). | c |
| b |
16.Replace the screw you removed in step 13 (d).
17.Replace the lower panel.
18. Turn back on the main power.
Page 8