Quantum 9412/9112 A Output Voltage Adjustment, Serial Port, AC Input, Line Voltage Selection

Page 8

T2

Channel 2 output -- designed specifically for use as a solid-state laser Q-switch trigger and has all the capabilities of the other output channels, including several special modes which af- fect only the output of Channel 2.

Ext/Gate

External Trigger or Gate signal input -- used as either an external signal to trigger the genera- tion of pulses or as a gate signal to enable and disable the outputs.

Output Voltage Adjustment

The maximum output voltage of all output channels is adjusted by turning the potentiometer la- beled VOUT. Turn clockwise to increase the voltage, counter-clockwise to decrease the volt- age. The maximum voltage possible is 20 Volts into a high-impedance load or 10 Volts into a 50 Ohm load.

Serial Port

This is a 9-pin D-sub connector for the RS232 interface that comes standard with the 9412/9412A. It is pinned to be directly connected to a standard IBM-PC serial port -- use a straight-through cable (not a null modem cable) to connect to a PC.

AC Input

A standard IEC instrument-type cord should be used. The 9412/9412A is supplied with a power cord that fits the type of socket used in your country.

Before plugging in, please make sure that the voltage selection switch is set to the proper setting for your country (either 110V or 220V).

Line Voltage Selection

This switch is used to select the voltage level used in your country -- make sure that it is on the proper setting or the 9412/9412A could be damaged.

8

Image 8
Contents Parts List WarrantyIntroduction Technical SupportSafety Issues Custom ModificationsPage Page Item Button Controls and Connectors Front PanelDisplay Control ButtonsQC Connectors Back PanelOutput Voltage Adjustment Serial PortAC Input Line Voltage SelectionPage Page Page Numeric Input Mode Item Edit ModeOperating Instructions OverviewMode Pulse Modes Main MenuDuty Cycle Gate Gate SelectWidth and Delay Menus TnDly Tn DelayToPer To Period TnWid Tn Pulse WidthT2Gate T2EnableT2 Menus Store Configuration Store/Recall/Misc. MenusT2Wait T2*n T2 Period FactorRecall Configuration VolumeShot Counter FmarkPage 3 2 Command Language Command ProtocolComputer Interface Serial RS232 PinoutEcho Enabled Cycles ?crlf 100crlf Communication Protocol Command List Following table summarizes all the commandsCycles 9412/9412A Communication Commands Specifications DelaysOutputs Maintenance Replacing the FusePage Custom Features