Description
1.Special cord set
2.«start cleaning» button
3.
4.Station lift button for cartridge exchange
5.Display for cleaning programs
6.Display for cleaning fluid status
7.Station socket
8.Cleaning cartridge
9.Shaver foil protection cap
10.Shaver foil
11.Cutter block
12.Foil release buttons
13.Long hair trimmer
14.
15.Switch
16.Shaver charging lights (green)
17.Shaver
18.Pilot light
19.Shaver socket
Before shaving
If you wish, you may start shaving right away (if the shaver is charged). However, we recommend to follow the procedure described here:
•Using the special cord set (1), connect the socket of the Clean&Charge station (7) to an electrical outlet.
•Press the station lift button (4) to open the housing.
•Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).
•Carefully remove the lid from the cartridge.
•Slide the cartridge into the base of the station as far as it will go.
•Slowly close the housing by pushing it down until it locks.
eco normal intensive
cartridge | full |
| empty |
1
2
7