Before shaving
Prior to first use you must connect the shaver to an electrical outlet using the special cord set i or alternatively proceed as below.
Installing the Clean&Renew station
•Using the special cord set i, connect the station power socket 6 to an electrical outlet.
•Press the lift button 2 to open the housing.
•Hold the cleaning cartridge 7 down on a flat, stable surface (e.g. table).
•Carefully remove the lid from the cartridge.
•Slide the cartridge into the base of the station as far as it will go.
•Slowly close the housing by pushing it down until it locks.
The cleaning fluid display 1 will show how much fluid is in the cartridge:
«high» | up to 30 cleaning cycles available |
«low» | up to 7 cleaning cycles remaining |
«empty» | new cartridge required |
Charging and cleaning the shaver
Insert the shaver head down into the cleaning station. (The contacts t on the back of the shaver will align with the contacts 3 in the cleaning station).
If required, the Clean&Renew station will now charge the shaver. The hygiene status of the shaver will also be analyzed and one of the following cleaning program diodes 5 will light up:
«clean» | shaver is clean |
«eco» | short economical cleaning required |
«normal» | normal level of cleaning required |
«intensive» | high intensive cleaning required |
If the station selects one of the required cleaning programs, it will not start unless you press the «start cleaning» button 4. For best shaving results, we recommend cleaning after each shave.
clean
eco
normal intensive
autoselect
| ng |
|
|
| eco |
|
| normal |
| fa | intensive |
| high | auto select |
1 | low |
|
empty |
| |
| 2 |
|
| f | new |
|
|
| high | high |
low | low | low |
empty | empty | empty |
trim mer
ashablew
fast c
rt cleani |
| |
sta | ng | clean |
|
| |
|
| eco |
|
| normal |
fast clean | intensive | |
| auto select | |
| washable |
|
| art cleaning | clean |
| st | |
|
| normal |
| n | intensive |
| f ast clea | |
| high |
|
|
| auto select |
| low |
|
7