rt cleani |
| |
sta | ng | clean |
|
| eco |
|
| normal |
fast clean | intensive | |
|
| auto select |
| washable |
|
| art cleaning | |
| st | clean |
|
| eco |
|
| normal |
|
| n |
| high | f ast clea |
|
| |
|
| auto select |
| low |
|
empty
While cleaning is in progress, the respective cleaning program diode will blink. Each cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head and a heat drying process dries the shaver. Depending on the program selected the total cleaning time will range from 32 to 43 minutes.
The cleaning programs should not be interrupted. Please note that while the shaver is drying, the shaving head may be hot and wet. When the program is finished, the blue «clean» diode will light up. Your shaver is now clean and ready for use.
Fast cleaning
Push the «fast clean» button D to activate the fast clean program without drying. This program takes about 25 seconds only and is recommended when you do not have time to wait for one of the automatic cleaning programs. If you remove the shaver just after the program has finished, wipe off the shaver head with a tissue to avoid dripping.
Stand-by mode
10 minutes after completing the charging or cleaning session, the Clean&Renew station switches to the
Shaver display
The shaver display r shows the charge status of the battery on the left, and the hygiene status on the right. (6 dark segments are shown on each side when the battery is fully charged and the shaver is hygienically clean).
Battery segments:
During charging or when using the shaver, the respective battery segments will blink. When fully charged all 6 segments are shown. With decreasing charge the segments gradually disappear.
Low charge indicator:
The low charge segment provided with a red frame blinks to indicate that the charge has dropped below 20%. The remaining capacity is sufficient for 2 to 3 shaves.
8