Manual Operating Instructions
To Manually Lower Outboard Roll Stop:
Note: Actuator shown exploded from lift for clarity.
Roll Stop |
|
|
Actuator | Hairpin |
|
| Cotter | Detent Pin |
| 1 | 2 |
3
Outboard Roll Stop
1.Remove hairpin cotter from detent pin.
2.Remove detent pin to detach roll stop actuator from roll stop.
3.Push roll stop to the down (ramp - horizontal) position.
Note: The lift will not raise from ground level without the roll stop release pin reinstalled, which fully engages and activates the roll stop down switch (details below).
To Reengage Outboard Roll Stop:
1.Position shaft end of roll stop actuator between roll stop mounting tabs (ears). Align mounting holes. Note: Rotate roll stop to vertical position or position needed to align mounting holes.
Note: The lift will not raise from ground level without the roll stop release pin reinstalled, which fully engages and activates the roll stop down switch.
Roll Stop Down Switch
CAUTION
Push roll stop down switch inward when inserting detent pin. Failure to do so will result in switch breakage.
2.Read caution! Push the roll stop down switch inward (toward vehicle) and insert detent pin.
Failure to do so will result in switch breakage!
Push switch IN fully.
3.Insert hairpin cotter in detent pin to secure roll stop actuator to roll stop.
Before inserting detent pin.
Page 20