Braun 603E, 604XD, 604XC, 604XB, 855RH, 603A, 604XA Maintenance and Lubrication, Handrails and Bridge

Page 23

Maintenance and Lubrication

Maintenance is necessary to ensure safe and trouble-free lift operation. General preventive maintenance consisting of inspections of your lift system and cleaning the lift should be a part of your routine. When cleaning the lift, pay special attention to the roll stop opening, platform surface and bottom of platform. If mud, ice and/or snow build-up is apparent on platform surface, clean the area prior to use. Do not spray water inside of lift housing.

The lift-equipped vehicle should be stored in a garage or other sheltered place if possible, especially during inclement weather conditions. When the lift is not in use, the lift should be in the stowed position to keep foreign objects, rain, ice, snow, etc., from entering through the lift

opening or building up on the platform surface.

The UVL has been designed with many self-lubricating compo- nents. Lubricate the pivot points specified below approximately every four weeks (or 100 cycles) with a light penetrating type oil

(30 weight or equivalent). Severe conditions (weather, environment, heavy usage, etc.) may require more frequent lubrication.

Complete maintenance checks and lubrication procedures must be performed annually by an authorized Braun Corporation sale representative who has attended and been certified by the Braun UVL Sales and Service School. If the annual maintenance and lubrication procedures cannot be performed, or if there is any sign of lift

WARNING

Annual maintenance and lubrication proce- dures must be per- formed by authorized service personnel. Failure to do so may result in serious bodily injury and/or property damage.

damage, wear, abnormal condi- tion or improper operation, discontinue lift use immedi- ately. Contact your dealer or call The Braun Corporation at 1-800- THE LIFT. One of our national service representatives will direct you to an authorized service repairman who will inspect your lift.

Note: LPS2 General Purpose Penetrating Oil is available in eleven ounce aerosol cans from The Braun Corporation (part number 15807).

Axle Shaft

Handrails and Bridge

Outer Bearings

Plates: Lubricate

(2 places)

pivot points with light

 

oil (if so equipped).

Lifting Arm

Pivot Points

(2 places)

Outboard Roll

Stop Actuator

Pivot Points

(2 places)

Cylinder Clevis

Rod Pivot Points

(2 places)

Lifting Arm

Outboard Roll Stop

Pivot Points

and Lower Closure

(2 places)

Pivot Points (2 places)

Page 21

Page 22 Page 24
Image 23
Page 22 Page 24
Contents UVL Congratulations Warranty/Registration InstructionsTable of Contents UVL600 Series Lift Terminology Illustration Lift TerminologyDirection Lift Terminology DescriptionLift Components Lift Operation Safety Precautions Lift Operation SafetySafety Symbols Lift Operation Safety Keep Clear of Moving Parts Pre-Lift Operation NotesFully-Folded Up-vertical Wheelchair-equipped Occupant Lift Operating Instructions Control Switch Functions Lift Control SwitchesVertical Bridge Plate Engagement Manual Bridge Plate Operating InstructionsDual Manual Fold P Handrail Instructions Dual Stationary Handrail InstructionsTo Stow Handrails Dual Manual Fold U Handrail with Shield InstructionsTo Deploy Handrails Cable-Activated Platform Manual Release System Operation Safety Precautions at all timesManual Operating Instructions Read warning posted above! Before raising or lowering Read warning posted aboveTo Manually Move Platform Out Extend From Stow Position Release Valve To Manually Raise Platform To Floor LevelOpen Close Turn Outboard Roll Stop Manual OperationTo Reengage Outboard Roll Stop To Manually Lower Outboard Roll StopHandrails and Bridge Maintenance and LubricationDamage DecalsLift Series No Warranty/Registration InstructionsReturn Authorization Procedure Lift Model No.Lift Serial NoProviding Access to the World Braun UVL Series
Top Page Image Contents