Braun 603B, 604XD, 604XC, 604XB, 855RH, 603E, 603A, 604XA owner manual Lift Operation Safety

Page 8

Lift Operation Safety

Lift Operation Safety Precautions (continued)

WARNING Load and unload clear of vehicular traffic.

WARNING Do not overload or abuse. The load rating applies to both the raising and lowering func- tions - continuous lifting capacity is 750 lbs.

WARNING Do not operate or board the lift if you or your lift operator are intoxicated.

WARNING Do not raise front wheelchair wheels (pull wheelie) when loading (boarding) the platform.

WARNING Open lift door(s) fully and secure before operating lift.

WARNING Position and secure (buckle, engage, fasten, etc.) the wheelchair-equipped occupant seat belt (torso restraint) before loading onto the wheelchair lift platform.

WARNING Fold manual-fold handrails down before stowing lift.

WARNING Lift occupant must keep hands, arms and all other body parts within the lift occupant area and clear of moving parts.

WARNING Platform must be positioned at floor level when loading or unloading in and out of vehicle.

WARNING Do not use the outboard roll stop as a barrier (brake). Stop and brake wheelchair when fully loaded on the platform (manually stop and brake manual wheelchairs — stop powered wheelchairs with the wheelchair controls).

WARNING Turn powered (electric) wheelchairs off when on lift platform.

WARNING Press the DOWN switch until the entire platform rests on ground level (lowered fully) and the outboard roll stop is fully unfolded (ramp position) before loading or unloading a pas- senger at ground level.

WARNING Outboard platform roll stop must be fully unfolded (ramp position) before front and rear wheelchair wheels cross roll stop when loading or unloading at ground level.

WARNING Accidental activation of control switch(es) may cause unintended operation(s).

WARNING After manually releasing platform, stow platform and push manual release T-handle in fully and move platform in and out to engage platform lock before driving vehicle. Failure to lock platform may result in unintended platform deployment.

WARNING

WARNING

WARNING

WARNING

WARNING

WARNING

WARNING

Insert manual release T-handle fully before manually lowering or raising platform and manually move platform in and out to engage platform lock.

Maintenance and lubrication procedures must be performed by authorized (certified) service personnel.

Replace missing, worn or illegible decals.

Keep owner’s manual in lift vehicle at all times.

Never modify (alter) a Braun Corporation lift.

Do not use accessory devices not authorized by The Braun Corporation.

Do not remove any guards or covers.

Page 6

Image 8
Contents UVL Warranty/Registration Instructions CongratulationsTable of Contents Lift Terminology UVL600 Series Lift Terminology IllustrationLift Terminology Description DirectionLift Components Lift Operation Safety Precautions Lift Operation SafetySafety Symbols Lift Operation Safety Pre-Lift Operation Notes Keep Clear of Moving PartsFully-Folded Up-vertical Wheelchair-equipped Occupant Lift Operating Instructions Lift Control Switches Control Switch FunctionsManual Bridge Plate Operating Instructions Vertical Bridge Plate EngagementDual Stationary Handrail Instructions Dual Manual Fold P Handrail InstructionsTo Stow Handrails Dual Manual Fold U Handrail with Shield InstructionsTo Deploy Handrails Cable-Activated Platform Manual Release System Operation Safety Precautions at all timesManual Operating Instructions Read warning posted above! Before raising or lowering Read warning posted aboveTo Manually Move Platform Out Extend From Stow Position To Manually Raise Platform To Floor Level Release ValveOpen Close Outboard Roll Stop Manual Operation TurnTo Manually Lower Outboard Roll Stop To Reengage Outboard Roll StopMaintenance and Lubrication Handrails and BridgeDecals DamageWarranty/Registration Instructions Return Authorization ProcedureLift Model No.Lift Serial No Lift Series NoProviding Access to the World Braun UVL Series