Omega Vehicle Security HHTFO manual Error Codes, Analog Out Description

Page 22

7 ERROR CODES

The following error messages are displayed under certain error conditions:

RS-232

Err2

“- - . -”

Err5

Err6

Display

Err2

“- - - - -”

Analog Out	Description
	Internal memory checksum error. Memory corruption.
	Contact Omega.
Hi-Lo, 0.5 Hz*	Temperature out of maximum instrument limits or no signal
	Argument out of range
	Unrecognized command

*: The exact analog output behavior is a function of the command “o”; see previous Chapter.

Note that these error codes are not applicable when using the FOB100-SOFT software package. This high- level software package is programmed to automatically handle all types of errors, as outlined in the next section.

22

Image 22

Contents Hhtfo Page Introduction Page Introduction Hhtfo product specifications VDCCalibration Unpacking OptionsInstalling batteries Quick IntroductionMaking your first meaasurements Display description Hhtfo Thermometer Hardware ReferennceKeypad operation Setup menu Using the backlightLogging menu File naming convention Format sub-menuIcon definition Enable sub-menuStarting and stopping a logging session Rate sub-menuProbe connector Power jack10 RS232 communication interface Using Temperature Probes DescriptionPage Serial Communication Description Using Hyper Terminal in WindowsRS-232 help menu Detailed description of RS-232 commands HHTFO101HHTFO111A Typical temperature reading sequence Error Codes Analog Out DescriptionQuick tour of FOB100-SOFT Installing FOB100-SOFTGetting started with FOB100-SOFT Hardware and software requirementsWorking with the Configuration Window Adjusting a temperature offset Acquiring and viewing temperature data Logging temperature data to a fileYour mouse to widen this column Viewing temperature data Displaying temperature trendsDisplaying digital values Displaying analog thermometersDisplaying analog values dials FOB100 Console File menu FOB100-SOFT functionsConsole help menu Find Instruments RefreshWindow menu Help Menu