Omega Vehicle Security HHTFO manual

Page 4

Warning

Permanent damage may be done to the thermometer if the power supply connections are not done correctly. Only use the supplied 6VDC power supply module to operate the HHTFO; please note that this module will not charge any internal batteries.

This product does not contain any user-serviceable parts. Opening this precision instrument will void its warranty and disturb its factory calibration. Always seek servicing from an authorized Omega Engineering service depot.

Fiber optic probes are fragile, and will break if the bending radius becomes less than ~1cm, even temporarily. Probe breakages are not covered under the standard Omega warranty. Do not bend the last one cm of the probes!

4

Image 4
Contents Hhtfo Page Introduction Page Introduction Hhtfo product specifications VDCCalibration Unpacking OptionsInstalling batteries Quick IntroductionMaking your first meaasurements Display description Hhtfo Thermometer Hardware ReferennceKeypad operation Setup menu Using the backlightLogging menu File naming convention Format sub-menuEnable sub-menu Starting and stopping a logging sessionIcon definition Rate sub-menuProbe connector Power jack10 RS232 communication interface Using Temperature Probes DescriptionPage Serial Communication Description Using Hyper Terminal in WindowsRS-232 help menu Detailed description of RS-232 commands HHTFO101HHTFO111A Typical temperature reading sequence Error Codes Analog Out DescriptionInstalling FOB100-SOFT Getting started with FOB100-SOFTQuick tour of FOB100-SOFT Hardware and software requirementsWorking with the Configuration Window Adjusting a temperature offset Acquiring and viewing temperature data Logging temperature data to a fileYour mouse to widen this column Viewing temperature data Displaying temperature trendsDisplaying digital values Displaying analog thermometersDisplaying analog values dials FOB100 Console FOB100-SOFT functions Console help menuFile menu Find Instruments RefreshWindow menu Help Menu