Mobil Mounting Layout

Mobil Mounting

Plan the layout for easy operator access to the pump air controls, sufficient space to change drums, and a secure mounting platform.

Drum Mounting

1.Place the drum in the desired location.

2.Place the hold-down lugs (Y) or drum locators (X) around the drum base and bolt directly to the truck bet or mounting platform. See FIG. 8.

TDrum cover eyelets

UWing nuts

V Hold-down brackets

WHold-down rods

X Drum locators

YHold-down rod lugs

FIG. 8

Open Drum, Cover-Mounted Pumps

1.Remove the original drum cover.

2.Mount the new drum cover and fasten in place.

3.Guide the pump extension tube through the mount- ing gasket.

4.Align the drum cover eyelets (T) with the hold-down rods (W), install the cover brackets (V) and wing nuts (U) and tighten securely. See FIG. 8.

Installation

Closed Bung-Type-Drum, Cover-Mounted Pump

1.Insert the pump extension tube through the gasket

(Z) and drum cover (AA). Fasten the Fire-Ball 300 from the top and the Fire-Ball 425 from the bottom. See FIG. 9.

2.Slide the rubber grommet (BB), tapered end down, onto the extension tube and push it up against the pump base. See FIG. 9.

3.Guide the pump extension tube through the drum bung hole (CC) and place the cover on the drum. See FIG. 9.

4.Align the drum cover eyelets (T) with the hold-down rods (W), install the hold-down brackets (V) and wing nuts (U) and tighten securely. See FIG. 8.

ZGasket

AA Drum cover BB Grommet CC Bung Hole

FIG. 9

Installation and Operation