Graco 225 important safety instructions Closed Bung-Type-Drum Sturdi-Clamp-Mounted Pumps

Closed Bung-Type-Drum,

Sturdi-Clamp-Mounted Pumps

1.Remove the adjustable bung adapter fro the pump extension tube.

2.Screw the bung adapter (HH) into the bung hole.

3.Loosen the wing nuts (EE) and slide the clamp (DD) onto the pump extension tube, up to the base. See FIG. 10.

4.Holding the clamp onto the pump, insert the pump extension tube through the bung adapter, and lower the pump until the clamp rests on the edge of the drum. See FIG. 10.

5.	Install the sturdi-clamp so its upper jaw fits against	DD Clamp
	the pump base projection, its u-bolt (GG) fits around	EE Wing Nuts
	the extension tube, and its lower jaw fits against the	FF T-handle
	bung adapter. Tighten the wing nuts (EE). See FIG.	GG U-bolt
	10.	HH Bung adapter
6.	Tighten the T-handle (FF) firmly to the side of the
	drum.	FIG. 10

Installation

DD

EE

FF

GG

HH

14 Installation and Operation