Invacare CT7A user manual Removing Foldover Back Upholstery, Installing Foldover Back Upholstery

Removing Foldover Back Upholstery

8 BACK

Back Upholstery

1.Unfasten the two fastening flaps that secure the bottom of the existing back upholstery to the back canes.

2.Unfold the top of the back upholstery.

3.Lift up on the existing back upholstery and remove from the wheelchair.

Installing Foldover Back Upholstery

1.	Install the new back upholstery onto the back canes.
2.	Wrap the end of a fastening flap around the back cane.
3.	Insert the end of the fastening flap through the loop.
4.	Wrap the fastening flap around the back cane again and press firmly
	to secure.
5.	Fold the top of the back upholstery down over the back canes
	towards the front of the wheelchair.

Fastening Strips

Fastening Flap

Front of

Wheelchair

Fold

Fastening Flap

Loops

Back Canes

6. Press firmly to secure the fastening strips.

FIGURE 9 Removing/Installing Foldover Back Upholstery

8.5Back Height Adjustment

Observe the tautness of the back upholstery for reinstallation.

1.Remove the back upholstery cover and adjustable tension back upholstery. Refer to Removing/Installing the Back Upholstery Cover, Adjustable Tension Back Upholstery and Lumbar Strap on page 49.

￿ WARNING

Adjustment pin MUST be protruding through hole in back cane.

Ensure that both back cane inserts are at the same height BEFORE reassembling the wheelchair.

2.Press the adjustment pin on the back cane insert tube in and adjust the back height to one of four heights depending on original back height:

Part No 1167484 53 Invacare® Crossfire™T7A Wheelchair