Invacare CT7A user manual Repositioning the Camber Tube Clamp Socket Screws

11 WHEELS

Repositioning the Camber Tube Clamp Socket Screws

1.Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

2.Refer to Socket Screw Mounting Positions in to determine which socket screw(s) MUST be moved and to which mounting positions.

3.Remove the four socket screws and washers from both camber tube clamps.

4.Align the desired mounting positions of the camber tube clamps with the opening of the camber tube supports.

￿ CAUTION

Ensure one empty mounting position remains between the two socket screws, otherwise damage to the wheelchair may occur.

5.Install the four socket screws and washers into the desired mounting positions of both camber tube clamps. Hand tighten.

Ensure that both camber tube clamps are adjust to the same position in the camber tube support. This will ensure that the camber tube remains at 90° to each side frame.

6.Slide the camber tube forward or backward to adjust the wheelbase length to the desired position. Securely tighten the four socket screws.

7.Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

Camber

Tube

Support

Washers

Socket Screws

Camber Tube Clamp

Camber Tube

FIGURE 9 Repositioning the Camber Tube Clamp Socket Screws

Reversing the Camber Tube Clamp Direction

1.Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

2.Remove the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.

3.Rotate the camber tube so that the camber tube clamps face the opposite direction.

Invacare® Crossfire™T7A Wheelchair 70 Part No 1167484