Invacare CT7A user manual Limited Warranty

Page 7

1 GENERAL

1.2Limited Warranty

PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.

This warranty is extended only to the original purchaser/user of our products.

This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.

Invacare warrants the Crossfire frame to be free from defects in materials and workmanship for the original purchaser for the 5 years from the date of purchase. All component parts including, but not limited to folding back, camber tubes, caster forks are warranted against defects in materials and workmanship for a period of one year from the date of purchase except armrests and upholstery, push handle grips, bushings, bearings, and tires/tubes. If within such warranty period any such product shall be proven to be defective, such product shall be repaired or replaced, at Invacare's option. This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of any such product. Invacare's sole obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement.

For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you DO NOT receive satisfactory warranty service, please write directly to Invacare at the address on the back page. Provide dealer’s name, address, date of purchase, indicate nature of the defect and, if the product is serialized, indicate the serial number. DO NOT return products to our factory without our prior consent.

LIMITATIONS AND EXCLUSIONS: THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED, PRODUCTS SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE, COMMERCIAL OR INSTITUTIONAL USE, PRODUCTS MODIFIED WITHOUT INVACARE'S EXPRESS WRITTEN CONSENT, INCLUDING, BUT NOT LIMITED TO, MODIFICATION THROUGH THE USE OF UNAUTHORIZED PARTS OR ATTACHMENTS; PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT WITHOUT THE SPECIFIC CONSENT OF INVACARE, OR TO A PRODUCT DAMAGED BY CIRCUMSTANCES BEYOND INVACARE'S CONTROL, AND SUCH EVALUATION WILL BE SOLELY DETERMINED BY INVACARE. THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THESE INSTRUCTIONS.

THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES WHATSOEVER, WHETHER EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, AND THE SOLE REMEDY FOR VIOLATIONS OF ANY WARRANTY WHATSOEVER, SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS CONTAINED HEREIN. THE APPLICATION OF ANY IMPLIED WARRANTY WHATSOEVER SHALL NOT EXTEND BEYOND THE DURATION OF THE EXPRESS WARRANTY PROVIDED HEREIN. THE MANUFACTURER SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER.THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/PROVINCIAL LAWS AND REQUIREMENTS.

Image 7
Contents Invacare CrossfireT7A Wheelchair Invacare CrossfireT7A Wheelchair Contents Seat ANTI-TIPPER General SymbolsLimited Warranty General Guidelines SafetyWheelchair User Stability Warning Wheelchair Tie Down RestraintsOperating Information Repair and Service InformationSeat Positioning Straps Weight TrainingTire Pressure and Information Label Locations OverviewSerial Number Label Location Component Identification Typical Product Parameters  All specifications are approximate70, 75, 80 Back Upholstery FoldoverCasters Safety/Handling of Wheelchairs Safety/Handling of WheelchairsStability and Balance SAFETY/HANDLING of Wheelchairs Reaching, Leaning and Bending Forward Lengthening Wheelbase ShorteningReaching, Leaning Backwards Coping with Everyday Obstacles Reaching, Leaning Bending Forward BackwardsTipping Curbs TippingMoving Up Stairs StairwaysStairways Moving Down StairsTransferring To and From Other Seats EscalatorsSafety Inspection Checklist Safety InspectionInspect Initially Inspect/Adjust Weekly Inspect/Adjust Periodically Inspect/Adjust MonthlyMaintenance Maintenance Safety Precautions TroubleshootingSuggested Maintenance Procedures Replacing/Repairing Caster Tire/Tube Replacing/Repairing Rear Wheel Tire/Tube Tire wear is excessive if Footrest Adjusting/Replacing Standard FootrestReplacing the Footrest Adjusting Footplate Angle Adjusting the FootrestAdjustmentsDepth Adjusting Footplate DepthArms Installing the Swingaway Padded Armrest SocketLeft Side Armrest Socket Right Side Armrest SocketShort Mounting Plunger Pin Adjusting Height Installing/Removing/Adjusting the Swingaway Padded ArmrestRemoving Adjusting T-Arm Height  To remove the T-arm, reverse this procedureAdjusting T-Arm Position Unfolding/Folding the Back BackDetail C Detail a Folding the Back Detail B Unfolding the Back For this procedure, refer to Figure Back Angle AdjustmentRepeat Steps 2-6 for remaining back cane Detail D DetailSquare will align with Hole in adjustmentWhen installed This orientationOption Back Upholstery Cover Adjustable Tension Back Upholstery The back upholstery cover is designed for three reasons Adjustable Tension Back Upholstery Adjusting the Tautness of the BackRemoving the Back Upholstery Cover Removing the Adjustable Tension Back UpholsteryInstalling the Lumbar Strap Installing the Adjustable Tension Back UpholsteryDetail a Detail B Installing the Back Upholstery CoverBack Canes Detail E Removing/Installing Foldover Back UpholsteryFront Wheelchair Installing Foldover Back UpholsteryBack Height Adjustment Removing Foldover Back UpholsteryBack Cane Hole NumberInstalling Removing/Installing the Back FrameReplacing Seat Upholstery SeatDetail a Seat Angle AdjustmentDetail a Seat Angle Adjustment Invacare CrossfireT7A WheelchairReplacing the Wheel Lock Replacing/Adjusting the Wheel LocksAdjusting the Wheel Lock Wheel LocksChanging Wheel Lock Handle Position Replacing/Adjusting the Wheel LocksWheel Lock Detail a Wheel Lock in PUSH-TO-LOCK ConfigurationConfiguration Converting From Pull-to-Lock to Push-to-LockWheels Removing/Installing Rear WheelsRemoving/Installing Rear Wheels Adjusting Quick-Release AxlesReplacing Quad-Release Axles Adjusting Quad-Release Handles In and/or OutRemoving Play from Rear Wheels Adjusting Quad-Release Handle In and/or OutHandrim Replacement Removing Play from Rear WheelsHandrim Replacement Repairing/Replacing Rear Wheel, Tire/TubeAdjusting Wheelbase Length, Adjusting Center Gravity COG Adjusting Wheelbase Length, Adjusting Center of Gravity COGFront Rear Wheelchair Socket Screw Mounting PositionsRepositioning the Camber Tube Clamps Repositioning the Camber Tube ClampsReversing the Camber Tube Clamp Direction Repositioning the Camber Tube Clamp Socket ScrewsCamber Tube Direction Facing Rear of Wheelchair OccurFacing Front of Wheelchair Adjusting Wheelbase Width Installing the Camber Tube Removing/Installing the Camber TubeRemoving the Camber Tube Detail a Correct Orientation for Each Camber Tube  Standright. behind the wheelchair to determine left or Adjusting the Camber TubeDetail a Side View  For this procedure, refer to on page 74 and Figure Determining/Setting Toe In/Toe OutTop View of Wheelchair Top View of Wheelchair Adjusting Fork TensionAdjusting Fork Tension  One mounting screw will not turn Removing/Installing/Repositioning the Caster AssembliesStandard Forks Suspension Forks Removing the CasterRemoving the Caster Installing the CasterInstalling the Caster One Sided ForkRemoving Fork Assembly Removing/Installing the Fork AssemblyInstalling Fork Assembly Detail C ONE Sided Fork Removing/Installing the Elastomers Suspension Forks OnlyDetail a Standard Fork Detail B Suspension ForkRemoving/Installing the Elastomers Suspension Forks Only Installing the ElastomerAnti-Tipper Adjusting/Replacing Anti-tipperReplacing Anti-tipper Adjusting Anti-tipperInjury or property damage Detail a ANTI-TIPPER Adjustment Holes211/8 Anti-Tipper Canada USA