Invacare CT7A user manual Removing/Installing the Camber Tube, Removing the Camber Tube

11 WHEELS

11.9 Removing/Installing the Camber Tube

￿ CAUTION

Camber tube clamps - Make sure the clamp screws are securely tightened before using the wheelchair, otherwise personal injury or damage to the wheelchair may occur.

Removing the Camber Tube

1.Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.

2.Loosen the two socket head clamp screws securing camber tube to the two camber tube clamps.

3.Slide the camber tube through he camber tube clamps.

Installing the Camber Tube

1.Insert the camber tube into the camber tube clamps.

2.Center the camber tube in the camber tube clamps.

3.Adjust the camber tube. Refer to Adjusting the Camber Tube on page 75.

There are four types of camber tubes: 0°, 3°,6° and 9°. If the camber tube being used is 3°,6° or 9° degrees, then the camber tube MUST be rotated so that the axle bushings at the ends of camber tube are angled up (Detail “A”). Installing the camber tube in any other orientation will directly impact the angle of the rear wheel.

Part No 1167484 73 Invacare® Crossfire™T7A Wheelchair