Invacare CT7A user manual Converting From Pull-to-Lock to Push-to-Lock, Wheel Lock, Pull-To-Lock

10 WHEEL LOCKS

10.3Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock Converting From Push-to-Lock to Pull-to-Lock

1.Remove set screw from the lower stop position (Detail “A”).

 As the wheel lock handle is pushed downwards, the wheel lock will engage and then disengage the wheel.

2.Push wheel lock handle down to access the upper stop position (Detail “B”).

3.Install set screw into upper stop position.

4.Pull wheel lock handle up to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock on page 59.

Converting From Pull-to-Lock to Push-to-Lock

1.Remove set screw from the upper stop position (Detail “B”).

 As the wheel lock handle is pulled upwards, the wheel lock will engage and then disengage the wheel.

2.Pull wheel lock handle up to access the lower stop position (Detail “A”).

3.Install set screw into lower stop position.

4.Push wheel lock handle down to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock on page 59.

DETAIL “A”

WHEEL LOCK IN PUSH-TO-LOCK CONFIGURATION

FIGURE 3

Part No 1167484

Set Screw (in Upper Stop Position)

Wheel Lock		DETAIL “B”
		WHEEL LOCK IN
Handle
	Wheel Lock	PULL-TO-LOCK
	Handle	CONFIGURATION
Set Screw
(in Lower Stop Position)
Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock
61	Invacare® Crossfire™T7A Wheelchair