Invacare 9000 STANDARD WEIGHT Elevating Legrest J934A-14 only, JA932A-14, J933A, J934A

Page 36

5FRONT RIGGINGS

5.3Heel Loop Replacement

Swingaway Footrests/Elevating Legrest (J932A, J932A-14, J933A and J934A)

1.Remove the four mounting screws and washers that secure the heel loop to the BOTTOM of the footrest.

2.Remove the heel loop from the footrest.

3.Position the new heel loop as shown in FIGURE 3 and reverse STEPS 1-2 to reassemble.

Elevating Legrest (J934A-14 ONLY)

1.Loosen, but do not remove the bolt and locknut that secure the lower half of the footrest to the swingaway footrest assembly.

2.Remove the lower footrest assembly.

3.Remove the mounting screw and locknut that secure the heel loop to the footrest.

4.Slide heel loop over cane of the footrest assembly.

5.Replace heel loop.

6.Reverse STEPS 1-4 to reassemble.

 When securing the heel loop to the footrest assembly, tighten the mounting screw and locknut until the spacer is secure.

	JA932A,	Mounting Screw	Bolt and Locknut
	JA932A-14,		Bolt and Locknut


	J933A, J934A		Heel Loop
		Spacer	Heel Loop
		Spacer
	Footrest	Heel Loop	Cane
	Footrest	J934A-14

	Washer
	Washer
	Mounting Screw		Lower Footrest
		Locknut	Assembly
		Locknut
	FIGURE 3 Adjusting the Elevating Legrest Assembly
	Invacare® Jymni™ Pediatric Series Wheelchair	36	Part No 1100868

Image 36

Contents Page Invacare Jymni Pediatric Series Wheelchair Contents Arms ANTI-TIPPERS/WHEEL Locks Symbols GeneralLimited Warranty Overview Label LocationsCrossmember Lower Frame TubeOn all adjustable Anti-tippers Models with Quick-Release Axles OnlyJymni Recliner Models Only Typical Product Parameters 19 or 23 inches Permanent35½ to 39¼ inches AluminumComponent Identification Front CasterSafety General GuidelinesOperating Information Anti-tippers General Warnings Hand Grips Repair and Service Information Information for Healthcare Professionals/Assistants LiftingRamps, Slopes, Inclines and Obstacles Weight Limitation Weight TrainingSeat Positioning Strap Tire PressureWheel Locks Wheelchair Tie Down RestraintsWheelchair User Safety/Handling of Wheelchairs Stability and BalanceRecliner Models Only Refer to the procedure that is checked to maintain Reaching, Leaning and Bending Forward or Sideways ForwardBackwards Coping With Everyday Obstacles TippingMethod 1 Wheelchair With Step Tubes Step TubeStairways Method 2 Wheelchair Without Step TubesMoving Up Stairs Moving Down StairsEscalators Transferring To and From Other SeatsUnfolding and Folding Wheelchair Unfolding Sling SeatFolding Sling Seat Unfolding/Folding Solid Seat Model WheelchairsSafety Inspection/Troubleshooting Safety Inspection ChecklistInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust MonthlyTroubleshooting Inspect/Adjust PeriodicallySolutions Casters SqueaksMaintenance Maintenance Safety Precautions Suggested Maintenance ProceduresDamage may result Replacing/Repairing Rear Wheel Tire/Tube Replacing/Repairing Caster Tire/Tube Transporting the Invacare JymniInstalling Installing/Removing the Swingaway Footrest AssemblyFront Riggings RemovingSwingaway Footrest Height Adjustment Upper Footrest Support Bolt Locknut Lower Footrest AssemblyJ932A-14 J932A and J933AElevating Legrest J934A-14 only JA932AJA932A-14 J934A-14Installing/Removing Elevating Legrest Assembly StepSteps 2 Lowering Legrest Assembly Adjusting CalfpadAdjusting Height Detail aAdjusting Armrest Height Adjust armrest to one of five positionsArms Using Swing-Back Arms Armrest Release Lever Rear Arm SocketRemoving or Replacing Armrest Removing ArmrestsReplacing Armrests PostGuard to the armrest assembly Mounting Screws Clothing Guard Armrest Pad AssemblyReplacing Clothing Guards Fixed Height Arms Only Converting Between Space Saver and Conventional ArmsSpace Saver Arm Position Conventional Arm PositionSeat and Back Replacing Seat UpholsteryReplacing Back Upholstery Washer Mounting Screws Back Upholstery Back CaneBack Cane Wheelchair Frame Locknuts Mounting Screws Adjusting Back Height Cane to the wheelchair frame are not shown for clarityAdjusting Seat Width and Depth Removing/Installing Rear Wheels Rear WheelsPermanent Axles Quick-Release Axles Detail a Detent balls and detent pinInside Wheelchair Outside WheelchairAdjusting the Quick-Release Axle Wheelchair Frame Locknut Locking PinsReplacing Rear Wheel Handrim Replacing Rear Wheel HandrimInstalling/Replacing Front Casters and Forks Front CastersReplacing/Repairing Front Caster Tire/Tube Adjusting Front Caster MountingInstalling/Adjusting Anti-tippers Anti-tippers/Wheel LocksInstalling Anti-Tippers 1101959 1058752Anti-Tipper Release Buttons Rear Frame Tubing Anti-Tipper LengthAdjusting Anti-Tippers InchesUsing Patient Operated Wheel Locks Push-To-LockPull-To-Lock Pull wheel lock handle toward the tire to engage wheel lockAdjusting Patient-Operated Wheel Locks Adjusting Patient-Operated Wheel LocksWheel Lock Wheel Lock Shoe Rear Wheel Inch 3/16-inch pneumatic tires Wheel Lock Shoe TireRecliner Operating ReclinerUpright Position Reclined PositionInstalling/Removing Headrest Extension Replacing Headrest PillowReplacing Headrest/Back Upholstery Headrest Upholstery Back UpholsteryKnob Back Upholstery Adjusting Headrest/Back Upholstery Tension Storing/Replacing Spreader Bar Storing Spreader BarRemoving From Stored Position Headrest Upholstery Spreader Bar BackAdjusting the Seat Width and Depth Placing In Stored PositionReplacing Spreader Bar Installing Telescoping I.V. Rod/O2 Holders OptionsCleaning Detail a I.V. Rod/O Detail B O 2 holder HolderTie Wrap Step Tube LocknutInstalling the 1-inch Forward Rear Wheel Positioner Wheel PositionerInstalling/Adjusting Stroller Handles Removing Height AdjustmentRepeat Steps 1-3 for the opposite stroller handle Repeat Steps 1 3 for the opposite stroller handleInstalling/Removing the Solid Seat Insert Installing Installing/Removing the Solid Back InsertInstalling the Wheel Lock Extension Handle Invacare Jymni Pediatric Series Wheelchair Invacare Jymni Pediatric Series Wheelchair Canada One Invacare Way