Leica MZ16 FA, MS5 Swinging-arm stand ESD, Safety ring column, Be fixed beneath the cross-member

Swinging-arm stand ESD

The swinging-arm stand ESD is of conducting material (surface resistance <1011 Ohm/squared, discharge time <2 seconds from 1,000 V to 100 V). Two sockets for connecting ∅ 4 mm ground cables are provided on the base.

Assembly of column ➜ ￿ Insert 4 Allen screws into the base base from beneath and secure them to

the end of the column.

Safety ring ➜ column	The safety ring secures the instrument and must always
	be fixed beneath the cross-member.

￿Slide the safety ring down the column.

￿Retighten the clamping screw.

Cross-member ➜	￿ Lower the cross-member onto the
column	safety ring.
	￿ Retighten the clamping screw.

Horizontal arm ➜ ￿ Slide the horizontal arm into the cross member cross-member with the connecting

piece towards you.

￿Retighten the clamping screw.

Drive housing ➜ • The drive housing / microscope carrier can be fitted to horizontal arm the horizontal arm in either of two positions (see page 34).

•The circular port in the microscope carrier accepts an illuminator.

￿Insert the peg of the inclinable focusing

drive into the connecting piece. ￿ Retighten the clamping screw.

Optics carrier ➜	￿ Fit the optics carrier in the
microscope carrier	microscope carrier.
	￿ Turn the optics carrier sideways in
	the microscope carrier as required.
	￿ Retighten the clamping screw.

28 Leica M Stereomicroscopes – Assembly