Binocular tube
Release the clamping screw.
•If you have an accessory such as an ergo module (page 14), a coaxial illumi- nator (page 47) or a video/phototube (page 52), fit it now to the optics carrier. Tighten the clamping screw.
Tilt the binocular tube and insert the edge of its dovetail ring beneath the two lugs on the optics carrier.
Move the binocular tube from side to
side until the locating screw on the optics carrier engages the guide.
Retighten the clamping screw.
Optical accessories
Eyepiece Insert a graticule, if necessary (page 56).
Release the clamping screws on the eye-
pieces.
Insert the eyepieces fully into the eye- piece tubes. Check that they have seated correctly.
Tighten the clamping screw.
• You can extend the overall magnification range by using 10⋅, 16⋅, 25⋅ and 40⋅
Objective Hold the objectives during assembly and disassembly to pre- vent them from falling on the stage plate. This applies particu- 
larly to the 2⋅ planapochromatic objective, which is very heavy. Remove the specimens from the stage plate.
Screw on the selected objective counter-
clockwise.
•Some instrument configurations require spacer rings in order to secure the objectives (page 32). These rings are fitted and removed using the tool provided.
•The Leica MZ95 is supplied with a spacer ring for the achro- matic objectives and for the 1⋅ planachromatic objective. When the spacer ring has been removed by applying the tool provided, the
Leica M Stereomicroscopes – Assembly | 35 |