Building the configuration file:
•Launch the IP phone manager software
Once the software is launched click on the “Auto Config” tab.
Click on Terminal
The basic settings needed to get the phone working out of the box are:
1st server address
1st server port
Assign the IP address programmed in
PRG 10‐12‐09 to 1st server address.
Assign port 5080 to first server port.
Document No. SIB 244 | Page 29 of 52 | 1st July 2008 |
NEC Australia Pty Ltd shall not be liable for any direct, indirect, consequential or incidental damages about the use of the information included in this document. The information in this technical documentation is advisory in nature and is subject to change. NEC may make improvements and changes in the products described in this documentation without notice. Contents of this document are subject to change without prior notice at the discretion of NEC Australia Pty Ltd. This document has been prepared for use by employees and dealers of NEC Australia Pty Ltd and may not be reproduced without prior written approval of NEC Australia Pty Ltd.