Extron electronic MGP 464 HD-SDI manual Input configuration submenu adjustments

PRELIMINARY

Operation, cont’d

Input configuration submenu adjustments

The table below shows how to make the selections and adjustments that are accessed through the Input Configuration submenus.

Input Configuration submenu		Horizontal Knob Adjustment	Vertical Knob Adjustment
Video type		Select input #1, 2, 3, or 4.	Select the desired video format
The following video signal types are			for the displayed input.
accepted:			Default: RGB
RGB	S-video
YUV-HD	Composite video
YUVi	DVI (MGP 464 DI and
	MGP 464 HD-SDI only)
RGBcvS	HD-SDI
	(MGP 464 HD-SDI only)
Film mode		Select input #1, 2, 3, or 4.	Select On or Off to turn 3:2 or 2:2
For low resolution inputs. The video		Shows the current film mode	pulldown (film mode) on and off
			for the selected input.
signal type for the input you are		status for the displayed input:
configuring must be set to YUVi,		On, Off, or na (not
composite video, or S-video in order
		applicable).
to place the input in film mode.
Vertical start position		Select input #1, 2, 3, or 4.	Increase or decrease the distance
The distance in pixels from the		Shows the current vertical	in pixels from the top edge of
			the video display’s total area to
top edge of the input’s total video		start point for the displayed
			the top edge of its active area.
display area to the top edge of its		input.
			Default is 128.
active area
Horizontal start position		Select input #1, 2, 3, or 4.	Increase or decrease the distance
The distance in pixels from the		Shows the current horizontal	in pixels from the left edge of
			the video display’s total area to
left edge of the input’s total video		start point for the displayed
			the left edge of its active area.
display area to the left edge of its		input.
			Default is 128.
active area
Pixel phase 1		Select input #1, 2, 3, or 4 for	Increase or decrease the
The point at which pixels are		window 1.	displayed value to move the pixel
			sampling point for window 1 to
sampled for window 1. (The values
			an optimal sampling point that
cannot be changed when the input
			ensures output clarity. The range
is DVI, YUVi, S-video, or composite
			of settings is 0-31; default is 16.
video.)
Pixel phase 2		Select input #1, 2, 3, or 4 for	Increase or decrease the
The point at which pixels are		window 2.	displayed value to move the pixel
			sampling point for window 2 to
sampled for window 2. (The values
			an optimal sampling point that
cannot be changed when the input
			ensures output clarity. The range
is DVI, YUVi, S-video, or composite
			of settings is 0-31; default is 16.
video.)

3-10 MGP 464 • Operation