Extron electronic MGP 464 HD-SDI manual MGP’s IP address Gateway IP address, Dhcp off

PRELIMINARY

Installation, cont’d

You must also configure the LAN port before using it. You can do this by using SIS commands (see “Command/response table for SIS commands” in chapter 4, “Software Configuration and Control”) or by using the Comm./IP Configuration menu on the front panel (see “Comm./IP Configuration menu” in chapter 3, “Operation”).

LAN port defaults:

•MGP’s IP address: 192.168.254.254

•Gateway IP address: 0.0.0.0

•Subnet mask: 255.255.0.0

•DHCP: off

E	Reset button — Pressing this recessed button causes various IP functions and
	Ethernet connection settings to be reset to the factory defaults.
F	Reset LED — This green LED, located to the upper-right of the reset button,
	blinks a varying number of times to indicate which reset mode has been
	entered. See “Resetting the unit” in chapter 3, “Operation,” for details.
G	BNC output connectors — Plug an output device into these five BNC
	connectors, as shown below.

	RGBHV			RGBS
	R	G	B	R	G	B
	/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
	H	V		H	V
	/HV			/HV
	R	G	B	R	G	B
	/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
	H	V		H	V
	/HV			/HV
	RGsB			HD YUV Component Video
Connecting to output BNC connectors
H						DVI-D OUTPUT
	DVI output — Plug a DVI output device into this
	DVI-I connector.

NAnalog RGB is not available on the DVI connector.

NWhen two output devices are attached (one to each output connector), they both display the same image.

I	DVI background input — Connect a DVI input source to this DVI-I connector
	in order to display the DVI video source live as a background on your output
	screen. The four MGP windows are displayed in front of this DVI image.
	When a DVI background is used, the MGP output is locked to the input rate
	of the DVI background. This input is not scaled.

NThis input connector can be used only to receive the background image. The input is not scaled or processed. To process DVI input signals, you must use the MGP 464 DI model.

2-8 MGP 464 • Installation