Extron electronic MGP 464 HD-SDI manual Operation, cont’d, Power-up and Default Cycle

Operation, cont’d

1 6

5 9

6 feet

(1.8 m)

Part #70-335-01

Tip

Ring

Sleeve (Gnd)

PRELIMINARY

9-pin D	Connection	TRS Plug
Pin 2	Computer's RX line	Tip
Pin 3	Computer's TX line	Ring
Pin 5	Computer's signal ground	Sleeve

Optional 2.5 mm connector cable for the front panel Config port

See chapter 4, “Software Configuration and Control,” for details about using the configuration software and the SIS commands to configure the MGP.

Power-up and Default Cycle

When you first plug the MGP 464 into a power source, the LCD screen displays

a series of initial messages, followed by the default cycle of screens showing the current input type for each window and the output resolution and refresh rate. These messages continue to cycle on the LCD screen when the menu system is not in use. The following flow diagram shows the order in which these screens appear.

	Extron
	MGP 464	Vx.xx
Power	Extron
on	MGP 464 DI	Vx.xx
	Extron
	MGP 464 HD-SDI Vx.xx
			2 sec.
	Multi-Graphic
	Processor
	2 sec.

Default Cycle

Window 1		DVI		Window 2		RGB		Window 3	RGB
000.0 kHz	000.0 Hz		2 sec.	000.0 kHz 000.0 Hz			2 sec.	000.0 kHz	000.0 Hz
2 sec.									2 sec.
		Output Rate				Window 4		RGB
		1280 x 1024 @ 60 Hz			2 sec.	Freeze Enabled

Default cycle example

NFrom any menu or submenu, the MGP 464 saves all adjustment settings and times out to the default screens after 20 seconds of inactivity.

3-4 MGP 464 • Operation