Extron electronic MGP 464 HD-SDI manual Activity LED This yellow LED blinks to indicate

Pin	RS-232 function	Description
1	–	No connection
2	Tx	Transmit data
3	Rx	Receive data
4	–	No connection
5	Gnd	Signal ground
6	–	No connection
7	–	No connection
8	–	No connection
9	–	No connection

Pin	RS-422 function	Description
1	–	No connection
2	Tx-	Transmit ground
3	Rx-	Receive ground
4	–	No connection
5	Gnd	Signal ground
6	–	No connection
7	Rx+	Receive data
8	Tx+	Transmit data
9	–	No connection

NThe MGP 464 also has an RS-232-only Config port on a 2.5 mm TRS connector on the front panel. For information on this port, see “Front Panel Features” in chapter 3, “Operation.”

D	LAN connector — Plug an RJ-45 network cable into this
	connector to connect the unit to a network (via a switch,
	hub, or router) or to a single computer.
	Activity LED — This yellow LED blinks to indicate
	network activity.
	Link LED — This green LED lights to indicate a good
	network connection.

LAN

RJ-45

Port

Link

LED

Activity

LED

Use a straight-through cable to connect to a network, or a crossover cable to connect directly to a computer.

•For 10BaseT (10 Mbps) networks, use a Cat 3 or better cable.

•For 100BaseT (max. 155 Mbps) networks, use a Cat 5 cable.

RJ-45 connector

Pins:

12 3 4 5 6 7 8

Side View

Insert

twisted pair wires.

Straight-through Cable

(for connection to a switch, hub, or router)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-orange
2	orange	2	orange
3	white-green	3	white-green
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	green
7	white-brown	7	white-brown
8	brown	8	brown

Crossover Cable

(for direct connection to a PC)

	End 1		End 2
Pin	Wire Color	Pin	Wire Color
1	white-orange	1	white-green
2	orange	2	green
3	white-green	3	white-orange
4	blue	4	blue
5	white-blue	5	white-blue
6	green	6	orange
7	white-brown	7	white-brown
8	brown	8	brown

PRELIMINARY

MGP 464 • Installation 2-7