Extron electronic MGP 464 HD-SDI manual Control

Command/response table for IP SIS commands (continued)

4-32 MGP 464 • Software Configuration

PRELIMINARY

Command	ASCII (Telnet)	URL Encoded (Web)	Response	Additional description
	(host to processor)	(host to processor)	(Processor to host)
IP setup commands (continued)
Set administrator password	E X3# CA }	W X3# CA	Ipa • X4! ]	Set administrator access password X3#.
				X3# = 4 to 12 alphanumeric characters. The
				password is case sensitive. Special characters
				(spaces or symbols) are not allowed.
				X4! = password displayed as four asterisks
	E • CA }	W %20 CA	Ipa • ]	(****).
Clear administrator password24				Clear/remove all passwords (administrator

and user).

NA user password cannot be assigned if an administrator password does not exist. Entering a password when the MGP 464 has not been configured yields an E14 error response from the processor. If the administrator password is cleared (removed), the user password is removed also.

SIS™ Programming and

and

View administrator password	E CA }	W CA	X4! ]
Set user password14 24	E X3# CU }	W X3# CU	Ipu • X4! ]

View password level X4!, shown with leading zeros.

Set user password X3# (4-12 alphanumeric characters). The password is case sensitive. Special characters (spaces or symbols) are not allowed.

Control,

Control

NA user password cannot be assigned if an administrator password does not exist.

Clear user password24	E • CU }	W %20 CU
View user password	E CU }	W CU
Set extended level password24	E X5! , X3# CO }	W X5! 2%C X3# CO
Clear extended level password24	E X5! , CO }	W X5! 2%C CO
View extended level password	E X5! CO }	W X5! CO
Set read-only security level support24	E X6^ * X6* EP }	W X6^ %2A X6* EP

Ipu • ]

X4! ]

Ipo X5! • X4! ]

Ipo X5! • ]

X4! ]

Pvo X6^ * X6* ]

Clear the user password only.

View password level X4!, shown with leading zeros.

Set password X3# for security level X5!. X5! = 1 through 10.

Remove password from security level X5!.

View password level X4!, shown with leading zeros.

Enable no-password login at security level

X6*.

For X6^:

0 = no-password logon disabled

1 = no-passwors logon enabled For X6*:

0 = no-password logon is placed one level below the lowest existing password level (0 through 11).

1 through 11 = no-password logon enabled at the level specified if an admin. password exists.

cont’d