Extron electronic MGP 464 HD-SDI manual Reset Mode Comparison/Summary

Reset Mode Comparison/Summary

Mode Activation		Result	Purpose/Notes
1	Hold in the recessed	Mode 1 causes the MGP to revert to the	Use mode 1 to
	Reset button (located	factory default firmware. Event	remove a version of
	next to the LAN	scripting does not start if the unit is	firmware if
	connector) while	powered on in this mode. All user files	incompatibility
	applying power to the	and settings are maintained.	issues arise.
	unit.
3	Hold in the Reset button	Mode 3 turns events on or off. During	Events must be
	for 3 seconds, until the	resetting, the Reset LED flashes 2 times if	turned on if you
	Reset LED blinks once.	events are starting; 3 times if events are	want to change IP
	Then, within 1 second,	stopping.	settings or
	press Reset again briefly		scheduling.
	(for less than 1 second).
4	Hold in the Reset button	Mode 4 does the following:	Mode 4 enables you
	for 6 seconds, until the	• Enables ARP capability.	to set IP address
	Reset LED has blinked	• Sets the IP address back to factory	information using	PRELIMINARY
	for 9 seconds, until the	factory defaults (except the firmware).	you want to start
	twice: once at 3 seconds	default.	ARP and the MAC
	and once at 6 seconds.	• Sets the subnet back to factory default.	address.
	Then, within 1 second,	• Sets the default gateway address back
	press Reset briefly (for	to the factory default.
	less than 1 second).	• Sets port mapping back to factory
		default.
		• Turns DHCP off.
		• Turns all events off.
		The Reset LED flashes 4 times in quick
		succession during reset.
5	Hold in the Reset button	Mode 5 performs a complete reset to	Mode 5 is useful if
	Reset LED has blinked	• Does everything mode 4 does.	over with control
	three times: once at	• Resets everything that was set via the	software
	3 seconds, once at	Real Time Adjustments part of the	configuration and
	6 seconds, and once at	control program: all video settings and	uploading, and to
	9 seconds. Then, within	miscellaneous options.	replace events.
	1 second, press Reset	• Resets all IP options.
	briefly (for less than 1	• Removes/clears all files from the
	second).	processor.
		The Reset LED flashes 4 times in quick
		succession during the reset.

NThe reset modes listed in the table above close all open IP and Telnet connections and all sockets. Also, each mode is a separate function, not a continuation from mode 1 to mode 5.

MGP 464 • Operation 3-27