![](/images/new-backgrounds/1251152/25115235x1.webp)
5505 Guest IP Phone Administration Guide
Pairing the 5505 Cordless Handsets
The 5505 Guest IP Phone supports up to four 5505 Cordless handsets. One handset comes from the factory
It is recommended that the handsets be paired after the 5505 Guest Phone has been registerered; however, if you wish to pair handsets on an unregistered 5505 Guest Phone, press the End Call key to end registration.
Note: Only one handset can be paired at a time. The pairing must be completed before pairing the next handset
1.On the 5505 Base Station, press down both the Volume Up/Down indicators on the Volume key.
2.Then release the Volume Down
3.While the Volume Up key is pressed, type 7247 (PAIR) on the base station to start the pairing process.
The Mute, Message and Line in Use keys start flashing to indicate an empty device slot is available for pairing.
4.On the handset, press MENU
5.Enter the Wireless PIN and press OK.
Registering ... appears on the handset.
Note: In ESM, refer to User and Device Configuration
After successful pairing, Handset Registered is temporarily displayed on the handset, and the indicators stop flashing on the base station. See “Maintenance and Troubleshooting” on page 39 if the handset didn’t register successfuly.
6.To verify successful registration, press the handset locator button (in the handset pocket on the base station). This will cause all paired handsets to start ringing.
7.Continue to pair the next handset, if necessary.
8.At any time, press the End Call key on the base station to exit from pairing mode.
12