MaxTech PCI Internal Voice/FAX/Data/Speakerphone Modem Force DSR Signal High on, Zn=x, +Ms?

&Q_	&Q0	Modem in asynchronous mode
&S_	&S0	Force DSR Signal High (ON)
	&S1 DSR is off in command mode, on in on-line
		mode
&T_	&T0	Ends test in progress
	&T1	Perform Local Analog Loopback Test
&U_	&U0	Enable Trellis Coding @ V.32
	&U1	Disable Trellis Coding @ V.32
&V_	&V0	Displays Active and Stored Profile 0
	&V1	Displays Active and Stored Profile 1
	&V3	Displays relay and general-purpose I/O
		status
&W_	&W0	Stores the active profile as Configuration
		Profile 0
	&W1	Stores the active profile as Configuration
		Profile 1
&Y_	&Y0	Configuration Profile 0 active upon
		Power on or reset
	&Y1	Configuration Profile 1 active upon Power
		on or reset
&Zn=x	n=0-3 Store telephone number x into non-volatile
		RAM
+MS?		Displays the current Select Modulation
		settings
+MS=?		Displays a list of supported Select
		Modulation options

+MS=a,b,c,d Select modulation where: a=V21, V22, V22B, V23C, V32, V.32B, V34, V.34S, V34B, V34BS, V90; b=0-1; c=0-33600; and d=0-33600. A, b, c, d default=V90, 1, 300, 0. Parameter “a” specifies the modulation protocol desired. Parameter

“b” specifies automode operations where: 0=automode disabled, 1= automode enabled. Parameter “ c” specifies the minimum connection data rate (0-56600). Parameter “d” specifies the maximum connection rate (0-56600), where a 0 specifies highest possible data rate, depending on the current DTE rate.

%E_ %E0 V.22bis auto-retrain disabled

10