| %E1 | V.22bis |
| %E2 | Enable line signal quality monitor and |
|
| fallback/fallforward |
%G_ | %G0 | Enable Auto Fall Forward/Back |
| %G1 | Disable Auto Fall Forward/Back |
Calling tone disabled | ||
| 1300hz calling tone | |
| V.8 and 1300hz calling tones enabled |
3.5MNP/V.42/V.42bis Commands
%An |
| Set | ||||
|
| (where n = 0 to 127, ASCII). Requires the | ||||
|
| \C2 setting. Default=13 |
|
| ||
%C_ | %C0 | Disable MNP Class 5 data compression | ||||
| %C1 Enable | MNP | Class | 5 | data | |
|
| compression |
|
|
| |
\A_ | \A0 | |||||
| \A1 | |||||
| \A2 | |||||
| \A3 | |||||
|
| size |
|
|
|
|
\Bn |
| Send a 1/10 second line break to the | ||||
|
| modem, where n = 1 to 9. At normal | ||||
|
| connect, the default is 0 |
|
| ||
\C_ | \C0 | Do not buffer data during LAPM/ | ||||
|
| MNP handshaking |
|
| ||
| \C1 | Buffer all data for 4 seconds, until | ||||
|
| receiving 200 characters or until a packet | ||||
|
| is detected |
|
|
|
|
| \C2 | Do not buffer data; switch to normal | ||||
|
| mode when fallback character is | ||||
|
| detected |
|
|
|
|
\G_ | \G0 | Disable DCE flow control |
| |||
| \G1 | Enable DCE flow control |
|
| ||
\J_ | \J0 | Disable serial port data rate | ||||
|
| adjustment (keep high data rate | ||||
|
| between | DTE | and | modem, | |
|
| regardless of | ||||
|
| data rate) |
|
|
|
|
| \J1 | Enable serial port data rate adjustment | ||||
|
| so serial data rate automatically adjusts | ||||
|
| to match the | ||||
\Kn |
| Set break | control, | where | n= 0 | to 5. |
11