Answering System Display Messages
The following messages show the status of the answering system or help you set up and use the system.
Indicates the total number of messages. | |
CL (blinking) | The voice time/day stamp needs to be set. |
- - | Answering system is turned off. |
An (blinking) | The system is answering a call. |
F (blinking) | Answering system memory is full. |
Six bars (blinking) | The system is recording a memo or |
| an announcement. |
LA (Line Access) | External line remote answering system. |
Troubleshooting Tips
Cordless Phone Solutions
No dial tone
•Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall jack.
•Connect another phone to the same wall jack; if it doesn’t work, the problem might be your wiring or local service.
•The handset may be out of range of the base. Move closer to the base.
•Make sure the battery is properly charged (16 hours).
•Make sure the battery pack (in the handset) is properly installed.
•The handset should beep when you press the talk/callback button, and the charge/in use indicator on the base should be lit when the handset rests in the cradle. If not, the battery may need to be charged.
•Place the handset in the base for at least 20 seconds to reset the unit.
30