Clarity RC100 Voice Activated answering RC200 only, Button on the keypad, ON/OFF indicator on

CHAPTER 5 (CONTINUED)

(Voice Activated answering

RC200 only)

1.	The voice activated Answering feature
	has been preset to OFF in the factory.
	To activate this feature, see page 5.
2.	Say "Hello" or whistle loudly, between
	rings. (If a headset is used, answer by
	speaking into the headset microphone.)
3.	Use the remote control, or press the
	ON/OFF button on the console to hang up.

Please Note:When the party that called you hangs up, the telephone company switching office may re-establish a dial tone on your line.

When dial tone returns, your

will hang up automatically. Prior to RC200

hanging up, the emits two short beeps as a reminderRC200.

D. Other Operations

Redialing the last number dialed
1.	Press the REDIAL	MUTE	FLASH/PAUSE
			REDIAL	ON/OFF
	button on the keypad.	HEADSET
		MIC
	OR
2. Press and hold the
	Remote Transmitter for		Figure 20
	3 seconds, until the	FLASH/PAUSE
	ON/OFF indicator on	REDIAL	ON/OFF

turnsDIALOGUEon. RC

Figure 21

Flash button

The flash button is used to access special tele- phone functions and services available from your local phone company, such as call waiting, 3–way calling, and others. Call your phone company for more information.

If you have the , you can use the Flash feature with theRC200Remote Transmit--ter.Turn the Remote Flash switch on (see Chapter 4 sec- tion C).When you are on the phone line, press the Remote Transmitter button twice in suc- cession, within three seconds, to generate the “flash”.

Voice Mail Indicator (VMI)
If you subscribe to voice mail service from
your phone company, the FLASH/PAUSE light
flashes and the RC beeps (once every 3.5 min-
utes) to inform you that you have voice mail
messages.You also hear a special "stutter" dial
tone sent from the phone
company.To retrieve your mes-
	UTE	FLASH/PAUSE
sages,follow the instructions	ADSET	ON/OFF
provided by your phone		REDIAL
company. Making an
outgoing call cancels the		Figure 22
indicator light.
Unanswered Call
Indicator	UTE	FLASH/PAUSE
If the RC rings three or more	ADSET	ON/OFF
		REDIAL
times and is not answered,
the FLASH/PAUSE light		Figure 23
flashes to indicate that you missed

a call.Turning on the RC cancels the indicator.

Telebanking and Credit Card Calling You can transmit account or personal identification numbers (PIN) from the RC by pre–storing them in memory.

Program account or PIN numbers into

1. a memory location in advance by following the same steps you would program a phone number.

When the automated phone system

2. requests it, press the memory button where your account number or PIN is stored.

8